Connecting your equipment
02
27
En
To improve AM reception, connect a 5–6 meter length of
vinyl-coated wire to the AM LOOP terminals without
disconnecting the supplied AM loop antenna.
For the best possible reception, suspend horizontally
outdoors.
Plugging in the receiver
Only plug in after you have connected all your
components to this receiver, including the speakers.
Caution
• Handle the power cord by the plug part. Do not pull
out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could
cause a short circuit or electric shock. Do not place
the unit, a piece of furniture, or other object on the
power cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other cables. The
power cords should be routed so that they are not
likely to be stepped on. A damaged power cord can
cause a fire or give you an electric shock. Check the
power cord once in a while. If you find it damaged,
contact the Pioneer Service Center specified on your
warranty card for a replacement.
• Do not use any power cord other than the one
supplied with this unit.
• Do not use the supplied power cord for any purpose
other than that described below.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular
use, eg., when on vacation.
1 Plug the supplied power cord into the AC IN
socket on the back of the receiver.
2 Plug the other end into a power outlet.
About the supplied AC power cords
This model has two power cords and plug converters.The
type of cord and the plug converter which can be used
depends on the power voltage in each region or country.
Please make sure you use the correct cord and plug
converter due to the possibility of fire or other hazard if
used incorrectly.
Check the table below for the correct AC cord (and
converter, if necessary) for your region.
ANTENNA
AM LOOP
ANTENNA
FM
75
Ω
UNBAL
Outdoor antenna
5–6 m
Indoor antenna
(vinyl-coated wire)
PAL model
Region Plug type
UK type region
UK three pin plug
European type region
European two pin plug
For regions with two pin flat-
bladed plug and 200 volts or
greater power supply
AC power cord (main unit)
AC adapter cord (recharger)
European two pin plug with two
pin flat-bladed converter plug (for
200 volts or greater power supply)
NTSC model
Region Plug type
European type region
European two pin plug
For regions with two pin flat-
bladed plug and 200 volts or
greater power supply
AC power cord (main unit)
AC adapter cord (recharger)
European two pin plug with two
pin flat-bladed converter plug (for
200 volts or greater power supply)
Taiwan
Taiwanese two pin flat-bladed plug