Filter
Top Products
Connecting your equipment
02
12
En
Chapter 2
Connecting your equipment
This receiver provides you with almost limitless possibilities for connecting your audio/video system, but it doesn’t
have to be difficult. Depending on your needs, you could be up and running in no time after a few simple connections.
This section has been designed so that you can read through this short introduction, then jump to the specific
connections that you need to make. For a basic home theater setup, you may only need to look through the TV, DVD
and speaker connections.
Rear panel
Caution
• Before making or changing the connections, switch
off the power and disconnect the power cord from the
power outlet. Plugging in components should be the
last connection you make with your system.
1 USB audio input
The USB audio input allows you to use your PC as a
playback source for stereo or multichannel digital audio.
See Using the USB interface on page 85 for connection
details.
2 Digital audio outputs
Two optical digital audio outputs for connecting to a CD,
MD or other digital recorder. See Connecting a VCR or
DVD recorder on page 18 for connection details.
3 Digital audio inputs
Three optical and three coaxial digital audio inputs for
connecting digital audio sources to this receiver. There’s
also a 2 RF IN jack for connection to an LD player with
a 2 RF output.
All the inputs are freely assignable to input functions for
maximum flexibility.
• If a connected component does not correspond to
the input function (DVD/LD, etc.), see Assigning the
digital inputs on page 88 to assign it properly.
4 Stereo analog audio source inputs/outputs
Four sets of analog audio jacks for connection to audio
sources such as CD players, tape decks and turntables.
The CD-R/TAPE 1/MD and TAPE 2 MONITOR functions
also feature outputs for recording. See Connecting
analog audio sources on page 22 for connection details.
5 Multichannel analog audio inputs
7.1 channel analog inputs for connection to a DVD player
with multichannel analog outputs. See Connecting the
multichannel analog outputs on page 16 for connection
details.
6 i.LINK connectors
Two S400-type i.LINK connectors allow you to connect
this receiver to other compatible i.LINK audio devices for
high-resolution, multichannel digital audio input/output.
See Using the i.LINK interface on page 83 for connection
details.
7 Turntable ground
A grounding (earth) terminal for use with turntables that
require it. See Connecting analog audio sources on
page 22 for connection details.
SU
R
-
R
OU
N
D
SU
R
-
VIDEO
SPEAK
(Single)
DVR/
VCR1
OUT
R
L
R
L
IN
IN
IN
OUT
OUT
OUT
1
2
DC
OU
T 12
V
T
O
TAL 1
00
mA MA
X
IN
IN
I
N
VCR2
OUT
IN
VCR
3
OUT
IN
L
RROUND BACK & B )
VIDEO
12V TRI
GG
E
R
S
S
SP
)
RROUNDBACK & B )
1
16
1