Filter
Top Products
Additional information11
60
En
When a search is performed
by a DTS compatible CD
player during playback, noise
is output.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Everything seems to be set up
correctly, but the playback
sound is odd.
• Check that the positive/negative speaker terminals on the receiver
are matched with the corresponding terminals on the speakers.
Refer to page 21 (VSX-415) or page 22 (VSX-515).
There seems to be a time lag
between the speakers and the
output of the subwoofer.
•
VSX-415 model only –
You may need to decrease the
Subwoofer
distance setting
on page 42
to compensate
for a delay in the
subwoofer output
.
•
VSX-515 model only –
See
Automatically setting up for surround
sound (MCACC)
on page 13 to set up your system again using
MCACC (this will automatically compensate for a delay in the
subwoofer output).
After using the Auto MCACC
Setup, the speaker size
setting (
LARGE
or
SMALL
) is
incorrect
(VSX-515 model
only)
.
• Low-frequency noise could have been caused by an air conditioner
or motor. Switch off all appliances in the room and rerun the Auto
MCACC Setup.
Can’t operate the remote
control.
• Replace the batteries (refer to page 6).
• Operate within 7 m, 30° of the remote sensor on the front panel
(refer to page 6).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press
FL DIMMER
on the remote control repeatedly to return to
the default.
Problem
Remedy
VSX_415-515.fm 60 ページ ２００５年１月２１日 金曜日 午後５時３分