Filter
Top Products
Listening to your system
06
35
En
English
Français
Deutsch
Nederlands
Italiano
Español
The MCACC indicator on the front panel lights
when Acoustic Calibration EQ is active.
1
Choosing the input signal
• Default setting:
AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
2
VSX-515 model:
VSX-415 model:
• Press
SIGNAL SELECT
to select the input
signal corresponding to the source compo-
nent.
Each press cycles through the options as
follows:
•
AUTO
– This automatically switches to
DIGITAL
if a digital source is detected,
otherwise it remains on
ANALOG
.
•
ANALOG
– Selects the analog inputs.
•
DIGITAL
– Selects the digital input.
When set to
DIGITAL
or
AUTO
,
2
DIGITAL
lights when a Dolby Digital signal is input, and
DTS
lights when a DTS signal is input.
Note
1• You can’t use Acoustic Calibration EQ when
DVD 5.1ch
is on, and it has no effect when headphones are connected.
• If you switch on Acoustic Calibration EQ when
DIRECT
is selected, the receiver automatically switches to
STEREO
.
2• This receiver can only play back Dolby Digital, PCM (32kHz–96 kHz), DTS and (VSX-515 model only) WMA9 Pro digital signal
formats. With other digital signal formats, set to
ANALOG
.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (page 16) and set the signal input to
DIGITAL
.
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
STANDARD
ADVANCED
SURR
ST/DIRECT
/AUTO SURR
SIGNAL
SELECT
LISTENING MODE
STANDARD
VSB
MODE
ADVANCED
SURROUND
STEREO/
DIRECT
LISTENING MODE
QUICK
SETUP
SPEAKER
IMPEDANCE
TONEMUTE
SIGNAL
SELECT
TUNER
EDIT
MULTI JOG
PTY
SEARCH
EON
MODE
VSX_415-515.fm 35 ページ ２００５年１月２１日 金曜日 午後５時３分