Filter
Top Products
Using the tuner09
56
En
5 If you want to keep listening to the
station, press ENTER within the 5 seconds.
If you don’t press
ENTER
, searching resumes.
If
NO PTY
is displayed it means the tuner
couldn’t find that program type at the time of
the search.
1
Using EON
When EON (Enhanced Other Network
information) is turned on, the receiver jumps to
an EON-linked broadcast when it begins, even
if a receiver function other than the tuner is
being used. It can’t be used in areas that EON
information isn’t transmitted and when FM
broadcast stations don’t transmit PTY data.
When the broadcast ends, the tuner returns to
the original frequency or function.
1 Press the
BAND
button to select the FM
band.
2
2 Press EON MODE to select one of the
possible modes.
Press repeatedly to switch between:
•
EON TA
(Traffic Announcement) – Sets the
tuner to pick up traffic information when it
is broadcast.
•
EON NEWS
– Sets the tuner to pick up
news when it is broadcast.
•
OFF
– Switches off the EON feature.
When set to
TA
or
NEWS
, the
EON
indicator in
the display lights (it flashes when receiving an
EON broadcast).
3
The indicator in the
display lights when the current station carries
the EON service.
4
Clearing all stations from the RDS
and EON searches
The receiver will automatically register an
identifying marker (called a PI code) for any
station you input into the memory classes
which can receive RDS or EON data. If you
want to remove the currently memorized
stations from RDS and EON searches, you can
do it by erasing the PI codes.
1 Press and hold EON MODE for about
two seconds.
ERASE PI
is displayed.
2 Press ENTER.
ERASE PI
flashes for two seconds to indicate
the PI codes have been erased.
Note
1 RDS searches station presets only. If no stations have been preset, or if the program type could not be found among the station
presets
NO PTY
is displayed.
FINISH
means the search is complete.
2 EON is only possible in the FM band.
3 You can’t search for traffic announcements and news at the same time.
4• You cannot operate the
TUNER EDIT
and
PTY SEARCH
buttons while the
EON
indicator in the display is lit.
• If you want to change to a function other than the tuner when the
EON
indicator is flashing, press
EON MODE
to turn EON
off.
VSX_415-515.fm 56 ページ ２００５年１月２１日 金曜日 午後５時３分