Filter
Top Products
The System Setup menu
08
51
En
English
Français
Deutsch
Nederlands
Italiano
Español
The Input Assign menu
You only need to make this setting if you didn’t
hook up your digital equipment according to
the default settings for the digital inputs (see
below). This setting tells the receiver what
digital equipment is hooked up to which
terminal so the buttons on the remote
correspond to what you have hooked up.
•
DIG. IN
default settings:
COAX 1
(coaxial) –
DVD
COAX 2
(coaxial) –
CD
OPT 1
(optical) –
TV
1 Select ‘IN ASSIG.’ from the System Setup
menu.
See
Making receiver settings from the System
Setup menu
on page 44 for more on this.
2 Select DIG. IN from the IN ASSIG. menu.
3 Select the number of the digital input to
which you’ve connected your digital
component.
The numbers correspond with the numbers
beside the inputs on the back of the receiver.
4 Select the component that corresponds
with the one you connected to that input.
Select
DVD
,
TV
,
CD
,
CDR
,
DVR
or
OFF
.
• Use the
/
(cursor up/down)
buttons
and
ENTER
to do this.
• If you assign a digital input to a certain
function (for example,
DVD
) then any
digital inputs previously assigned to that
function will automatically be switched off.
5 When you're finished, press RETURN.
The Other setup menu
The Other menu is where you can make
customized settings to reflect how you are
using the receiver.
1 Select OTHER from the System Setup
menu.
See
Making receiver settings from the System
Setup menu
on page 44 for more on this.
2 Use
/
(cursor left/right) to select the
setting you want to adjust then press
ENTER
.
If you are doing this for the first time, you may
want to adjust these settings in order:
•
DRC
– Specify the amount of dynamic
range adjustment to Dolby Digital
soundtracks (see
Dynamic Range Control
Setup
below).
•
DUALMONO
– Isolate one channel when
listening to discs with dual mono encoding
(see
Dual Mono Setup
below).
•
LFE ATT
– Set the attenuator level for the
LFE channel (
LFE Attenuator Setup
below).
3 Make the adjustments necessary for each
setting, pressing RETURN to confirm after
each screen.
Dynamic Range Control Setup
• Default setting:
OFF
This setting specifies the amount of dynamic
range adjustment to Dolby Digital and DTS
movie soundtracks. You may want to use this
when listening to surround sound at low
volumes.
1 Select DRC from the OTHER setup menu.
2 Use
/
(cursor up/down) to choose the
setting that you want.
•
OFF
– No dynamic range adjustment (use
when listening at higher volume).
•
MID
– Mid setting.
VSX_415-515.fm 51 ページ ２００５年１月２１日 金曜日 午後５時３分