Filter
Top Products
The System Setup menu
08
45
En
English
Français
Deutsch
Nederlands
Italiano
Español
1 Select ‘M MCACC’ from the System Setup
menu.
See
Making receiver settings from the System
Setup menu
above if you’re not already at this
menu.
2 Select the setting you want to adjust.
If you’re doing this for the first time, you might
want to make these settings in order.
•
CH LEVEL
– Make fine adjustments to the
overall balance of your speaker system (see
Fine Channel Level
below).
•
CH DISTN.
– Make precise delay settings
for your speaker system (see
Fine Channel
Distance
below).
The last five settings are specifically for
customizing the parameters explained in
Acoustic Calibration EQ
on page 46:
•
EQ A. SET
– Measure the acoustic
characteristics of your room and
automatically adjust the frequency balance
of your speaker system (see
Setting the
Acoustic Calibration EQ automatically
on
page 46).
•
EQ COPY
– Copy Acoustic Calibration EQ
settings for manual adjustment (see
Copying your Acoustic Calibration EQ
settings
on page 47).
•
C1 ADJ/C2 ADJ
– Make detailed manual
adjustments to your custom Acoustic
Calibration EQ settings (see
Setting the
Acoustic Calibration EQ manually
on
page 47).
•
EQ CHECK
– Check the
ALL CH
,
F. ALIGN
and custom settings (see
Checking your
Acoustic Calibration EQ settings
on
page 48).
Fine Channel Level
• Default setting:
0dB
(all channels)
You can achieve better surround sound by
properly adjusting the overall balance of your
speaker system. The following setting can help
you make detailed adjustments that you may
not achieve using the
Automatically setting up
for surround sound (MCACC)
on page 13.
1 Select ‘
CH LEVEL’
from the Manual
MCACC setup menu.
You’ll hear test tones from each speaker in
turn. Since the left speaker is the main
reference speaker, the level is fixed and cannot
be changed.
Caution
• The test tones used in the System Setup
are output at high volume (the volume
increases to
–18dB
automatically).
2 Use
/
(cursor left/right) to select each
channel in turn and adjust the levels
(
+/–
10dB
)
as necessary.
Use
/
(cursor up/down) to adjust the
volume of the selected speaker to match the
reference speaker. When it sounds like both
tones are the same volume, press
(cursor
left) to continue to the next channel.
• For comparison purposes, the reference
speaker will change depending on which
speaker you select.
• If you want to go back and adjust a
channel, simply use
/
(cursor left/
right) to select it.
3 When you're finished, press RETURN.
You will return to the Manual MCACC setup
menu.
VSX_415-515.fm 45 ページ ２００５年１月２１日 金曜日 午後５時３分