Filter
Top Products
The System Setup menu08
48
En
• The
OVER!!
indicator shows in the display
if the frequency adjustment is too drastic
and might distort. If this happens, bring the
level down until
OVER!!
disappears from
the display.
Tip
• Changing the frequency curve of one
channel too drastically will affect the
overall balance. If the speaker balance
seems uneven, you can raise or lower
channel levels using test tones with the
‘trim’ band (
TRM
shows in the display).
Use
/
(cursor left/right) to select
TRM
then use
/
(cursor up/down) to raise or
lower the channel level for the current
speaker.
4 When you're finished, press
RETURN
.
Press
RETURN
once more to go back to the
Manual MCACC setup menu.
Checking your Acoustic Calibration EQ
settings
After you have completed an automatic or
manual Acoustic Calibration EQ adjustment,
you can check the
ALL CH
,
F.ALIGN
and
CUSTOM1
/
2
settings in the display.
1 Select ‘EQ CHECK’ from the Manual
MCACC setup menu.
2 Use
/
(cursor up/down) and
ENTER
to
select the setting you want to check.
• It is useful to do this while a source is
playing so you can compare the different
settings.
3 Use
/
(cursor up/down) to select the
channel you want, using
/
(cursor left/
right) to check the settings.
The MCACC channel EQ indicators in the front
panel display will light accordingly.
4 When you're finished, press RETURN.
You will return to the Manual MCACC setup
menu.
Manual speaker setup
This receiver allows you to make detailed
settings to optimize the surround sound
performance. You only need to make these
settings once (unless you change the
placement of your current speaker system or
add new speakers).
These settings are designed to fine-tune your
system, but if you’re satisfied with the settings
made in
Automatically setting up for surround
sound (MCACC)
on page 13, it isn’t necessary
to make all of these settings.
1 Select SP SETUP from the System Setup
menu then press
ENTER
.
See
Making receiver settings from the System
Setup menu
on page 44.
2 Use
/
(cursor left/right) to select the
setting you want to adjust then press
ENTER
.
If you are doing this for the first time, you may
want to adjust these settings in order:
•
SP SET
– Specify the size and number of
speakers you’ve connected (see
Speaker
setting
below).
•
X.OVER
– Specify which frequencies will be
sent to the subwoofer (see
Crossover
network
below).
•
CH LEVEL
– Adjust the overall balance of
your speaker system (see
Channel level
below).
•
SP DISTN.
– Specify the distance of your
speakers from the listening position (see
Speaker Distance
on page 50).
Speaker setting
Use this setting to specify your speaker
configuration (size, number of speakers). It is a
good idea to make sure that the settings made
in
Automatically setting up for surround sound
(MCACC)
on page 13 are correct.
VSX_415-515.fm 48 ページ ２００５年１月２１日 金曜日 午後５時３分