Filter
Top Products
Other connections
10
55
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 10:
Other connections
Caution
•
Before making or changing the connections
,
switch off the power and disconnect the
power cord from the power outlet.
Plugging in components should be the last
connection you make with your system.
• Do not allow any contact between speaker
wires from different terminals.
• You can use speakers with a nominal
impedance between 6
Ω
to 16
Ω
(please
see
Switching the speaker impedance
on
page 72 if you plan to use speakers with an
impedance of less than 8
Ω
).
Connecting an iPod
This receiver has a dedicated iPod terminal
that will allow you to control playback of audio
content from your iPod using the controls of
this receiver.
1
Connecting your iPod to the receiver
1 Set this receiver to the standby mode,
and then use the USB cable (for iPod
connection) to connect your iPod to the iPod
DIRECT terminal on the front panel of this
receiver.
For the cable connection, refer to also the
operating instructions for iPod.
2 Switch the receiver on and press the
iPod
input source
button to switch the receiver to
the iPod.
The front panel display shows
Loading
while
the receiver verifies the connection and
retrieves data from the iPod.
3 Use the
TOP MENU
button to display
iPod Top menu.
When the display shows
Top Menu
you’re
ready to play music from the iPod.
2
• If after pressing
iPod
the display shows
No Connection
, try switching off the
receiver and reconnecting the iPod to the
receiver.
Note
1• This system is compatible with the audio of an iPod and iPod nano portable device (fifth generation and above). However,
that some of the functions may be restricted for some models. Note, however, compatibility may vary depending on the
software version of your iPod. Please be sure to use the latest available software version.
• iPod is licensed for reproduction of non-copyrighted materials or materials the user is legally permitted to reproduce.
• Features such as the equalizer cannot be controlled using this receiver, and we recommend switching the equalizer off
before connecting.
• Pioneer cannot under any circumstances accept responsibility for any direct or indirect loss arising from any inconvenience
or loss of recorded material resulting from the iPod failure.
MASTER
VOLUME
AM
SIRIUS
MCACC
PORTABLE
AUX
This receiver
USB cable (for
iPod connection)
iPod DIRECT
iPod
MENU
iPod
Music >
Extras >
Settings >
Shuffle Songs
Backlight
2 The controls of your iPod will be inoperable when connected to this receiver (
Pioneer
shows in the iPod display).
VSX_918_818_KU.book 55 ページ ２００８年５月１５日 木曜日 午後６時４６分