Filter
Top Products
The System Setup menu
06
39
En
English
Français
Deutsch
Nederlands
Italiano
Español
When it sounds like both tones are the same
volume, press
ENTER
to confirm and continue
to the next channel.
• For comparison purposes, the reference
speaker will change depending on which
speaker you select.
• If you want to go back and adjust a
channel, simply use
/
to select it.
3 When you’re finished, press RETURN.
You return to the Manual MCACC setup menu.
Fine Speaker Distance
• Default setting:
10.0ft
(all channels)
For proper sound depth and separation with
your system, it is necessary to add a slight bit
of delay to some speakers so that all sounds
will arrive at the listening position at the same
time. The following setting can help you make
detailed adjustments that you may not achieve
using the
Manual speaker setup
on page 42.
1 Select ‘Fine SP Distance’ from the
Manual MCACC setup menu.
The volume increases to the reference level.
2 Adjust the distance of the left channel
from the listening position.
After pressing
ENTER
, test tones will be
output.
3 Select each channel in turn and adjust
the distance as necessary.
Use
/
to adjust the delay of the speaker
you selected to match the reference speaker.
The delay is measured in terms of speaker
distance from
0.5
feet to
45.0
feet (0.1 m to 13
m).
Listen to the reference speaker and use it to
measure the target channel. From the listening
position, face the two speakers with your arms
outstretched pointing at each speaker.
Try to
make the two tones sound as if they are
arriving simultaneously at a position slightly in
front of you and between your arm span.
When it sounds like the delay settings are
matched up, press
ENTER
to confirm and
continue to the next channel.
• For comparison purposes, the reference
speaker will change depending on which
speaker you select.
2a.Fine Channel Level
L + 0.0dB (Reference)
R [ 0.0dB ]
C +1.0dB
LS [ –3.0dB ]
RS [ +10.0dB ]
SW [ –1.5dB ]
:Finish
2.Manual MCACC
:Return
a.Fine Ch Level
b.Fine SP Distance
c.EQ AUTO Setting
d.EQ Data Copy
e.EQ CUSTOM1 Adjust
f .EQ CUSTOM2 Adjust
g.EQ Data Check
2b.Fine SP Distance
L(Reference)
10.0ft
ENTER:Next :Cancel
2b.Fine SP Distance
L 10.0ft
(
Reference
)
R [ 9.0ft ]
C 9.5ft
LS [ 6.0ft ]
RS [ 6.5ft ]
SW [ 12.5ft ]
:Finish
VSX_918_818_KU.book 39 ページ ２００８年５月１５日 木曜日 午後６時４６分