Filter
Top Products
The System Setup menu06
44
En
1 Select ‘Crossover Network’ from the
Manual SP Setup menu.
2 Choose the frequency cutoff point.
Frequencies below the cutoff point will be sent
to the subwoofer (or
LARGE
speakers).
3 When you’re finished, press RETURN.
You return to the Manual SP Setup menu.
Channel Level
Using the channel level settings, you can
adjust the overall balance of your speaker
system, an important factor when setting up a
home theater system.
1 Select ‘Channel Level’ from the Manual
SP Setup menu.
2 Select a setup option.
•
Manual
– Move the test tone manually
from speaker to speaker and adjust
individual channel levels.
•
Auto
– Adjust channel levels as the test
tone moves from speaker to speaker
automatically.
3 Confirm your selected setup option.
The test tones will start after you press
ENTER
.
After the volume increases to the reference
level, test tones will be output.
4 Adjust the level of each channel using
/
.
If you selected
Manual
, use
/
to switch
speakers. The
Auto
setup will output test tones
in the order shown on-screen:
Adjust the level of each speaker as the test
tone is emitted.
1
5 When you’re finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• You can change the channel levels at any
time by using
CH SEL
and
LEVEL +/–
on the
remote control. You can set two channel
levels: one for
DVD 5.1CH
and one for the
listening modes.
3.Manual SP Setup
:Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
3b.Crossover Network
:Finish
Frequency 80Hz
3.Manual SP Setup
:Return
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
3c.Channel Level
Test Tone Manual
ENTER:Next :Cancel
Note
1• If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level
of each speaker to 75 dB SPL (C-weighting/slow reading).
• The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack.
3c.Channel Level
Test Tone [ Manual ]
Please Wait . . .20
Caution!
Loud test tones
will be output.
:Cancel
3c.Channel Level
L 0.0dB
C [ 0.0dB ]
R [ 0.0dB ]
RS [ 0.0dB ]
LS [ 0.0dB ]
SW [ 0.0dB ]
:Finish
VSX_918_818_KU.book 44 ページ ２００８年５月１５日 木曜日 午後６時４６分