Filter
Top Products
5 minute guide
02
9
En
English
Français
Deutsch
Nederlands
Italiano
Español
Make sure that the speaker cable you’re using
is properly prepared with about 10 mm of
insulator stripped from each wire, with the
exposed wire strands twisted together (
fig. A
).
Unscrew the terminal a few turns until there is
enough space to insert the exposed wire
(
fig. B
). Once the wire is in position, tighten the
terminal until the wire is firmly clamped (
fig. C
).
Where you place the speakers will have a big
effect on the sound. Place your speakers as
shown below for the best surround sound
effect. See
Hints on speaker placement
on
page 23 for more on this.
4 Plug in the receiver and switch it on,
followed by your DVD player, your
subwoofer and the TV.
Make sure you’ve set the video input on your TV
to this receiver. Check the manual that came
with the TV if you don’t know how to do this.
5 Press QUICK SETUP on the front panel to
specify your speaker setup, room size and
listening position.
Use the
MULTI JOG
dial to select and
ENTER
to confirm your selection. See
Using the Quick
Setup
below if you’re unsure about the
settings.
1
6 Play a DVD, and adjust the volume to your
liking.
Make sure that
DVD/LD
is showing in the
receiver’s display, indicating that the DVD
input is selected. If it isn’t, press
DVD/LD
on
the remote control to set the receiver to the
DVD input.
2
There are several other sound options you can
select. See
Listening to your system
on page 36
for more on this.
3
10mm
fig. A fig. B fig. C
Front
speaker
(L)
Surround
speaker (LS)
Surround
speaker (RS)
Surround back
speaker (SBL)
Surround
back
speaker (SBR)
Center
speaker
(C)
Subwoofer (SW)
Listening
position
Front
speaker
(R)
Note
1 See also
Making receiver settings from the System Setup menu
on page 46 for more setup options.
2• You may need to set your DVD player to output Dolby Digital, DTS and 88.2/96kHz PCM (2 channel) audio (see your DVD
player’s manual for more on this).
3 Depending on your DVD player or source discs, you may only get digital 2 channel stereo and analog sound. In this case, the
listening mode must be set to
STANDARD
(see
Listening in surround sound
on page 36 if you need to do this) if you want
multichannel surround sound.
VSX_815-915.book.fm 9ページ ２００５年３月１日 火曜日 午前１０時２２分