Filter
Top Products
Using the tuner08
56
En
Naming station presets
For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See
Listening to station presets
below for how
to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows
ST. NAME
, then a blinking
cursor at the first character position.
3 Input the name you want.
Choose a name up to four characters long.
• Use the
MULTI JOG
dial (front panel) or the
ST +/–
buttons (remote) to select
characters.
• Press
ENTER
to confirm a character. If no
character is input, a space is input.
• The name is stored when
ENTER
is pressed
after choosing the fourth character.
Tip
• To erase a station name, simply repeat
steps 1-3 and input four spaces instead of
a name.
• Once you have named a station preset, you
can press (
TUNER
)
DISPLAY
when
listening to a station to switch the display
between name and frequency.
Listening to station presets
You will need to have some presets stored to do
this. See
Saving station presets
above if you
haven’t done this already.
1 Press
TUNER
to select the tuner.
2 Press CLASS to select the class in which
the station is stored.
Press repeatedly to cycle through classes A, B
and C.
3 Press ST +/– to select the station preset
you want.
• You can also use the number buttons on
the remote control to recall the station
preset.
Changing the frequency step
If you find that you can’t tune into stations
successfully, the frequency step may not be
suitable for your country/region. Here’s how to
switch the setting:
VSX-515 model:
1 Switch the receiver into standby.
2 On the front panel, press
STANDBY/
ON
while you press and hold the
CLASS
button.
The channel tuning step alternates between
10K STEP
and
9K STEP
each time you do this.
VSX-815/915 model:
1 Switch the receiver into standby.
2 On the front panel, press
STANDBY/
ON
while you press and hold the
BAND
button.
The channel tuning step alternates between
10K STEP
and
9K STEP
each time you do this.
VSX_815-915.book.fm 56 ページ ２００５年３月１日 火曜日 午前１０時２２分