Filter
Top Products
Controlling the rest of your system
10
59
En
English
Français
Deutsch
Nederlands
Italiano
Español
Direct function
• Default setting:
ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component
you select (using the
MULTI CONTROL
buttons) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver.
1
1 While pressing the RECEIVER button,
press and hold the 4 button.
The LED blinks.
2 Press the MULTI CONTROL button for
the component you want to control.
The LED lights.
3 Use the number buttons to enter either
1 (direct on) or 2 (direct off).
The LED blinks again.
4 Repeat steps 2 through 3 for the other
components you want to control.
5 When you’re done, press RECEIVER.
Clearing all the remote control
settings
You can clear all presets and restore the
factory default settings.
• While pressing the RECEIVER button,
press and hold the 0 button for three seconds.
The LED blinks three times indicating the
settings have been restored to the factory
presets.
Note
1 You can’t use direct function with the
TUNER
function.
VSX_815-915.book.fm 59 ページ ２００５年３月１日 火曜日 午前１０時２２分