Filter
Top Products
Other connections
12
71
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 12:
Other connections
Caution
•
Before making or changing the connections
,
switch off the power and disconnect the
power cord from the power outlet.
Plugging in components should be the last
connection you make with your system.
• Be careful not to allow any contact
between speaker wires from different
terminals.
• You can use speakers with a nominal
impedance between 6–16
Ω
(please see
Switching the speaker impedance
on
page 81 if you plan to use speakers with an
impedance of less than 8
Ω
).
Second Zone speaker B setup
VSX-915 model only
After selecting
SB 2ND Z
in
Surround back
speaker setting
on page 46, you can use the
speakers connected to the (surround back) B
speaker terminals on the rear panel to listen to
stereo playback in another room. See
Switching the speaker system
below for the
listening options with this setup.
1 Connect a pair of speakers to the
surround back speaker terminals on the rear
panel.
Connect them the same way you connected
your speakers in
Connecting the speakers
on
page 22. Make sure to review
Hints on speaker
placement
on page 23 when placing the
speakers in another room.
2 Select
SB 2ND Z
from the ‘
SB. SYSTEM’
menu.
See
Surround back speaker setting
on page 46
to do this.
Switching the speaker system
If you selected
SB 2ND Z
in
Surround back
speaker setting
on page 46, three speaker
system settings are possible using the
SPEAKERS
button. If you selected
SB NORM.
or
SB BIAMP
, the speaker system is fixed as
SP
A
or
SP
AB
(respectively). The options
below are for the
SB 2ND Z
setting only.
1
• Use the SPEAKERS button on the front
panel to select a speaker system setting.
Press repeatedly to choose a speaker system
option:
•
SP
A
– Sound is output from the speakers
connected to the A speaker terminals
(multichannel playback is possible).
•
SP
B
– Sound is output from the two
speakers connected to speaker system B
(only stereo playback is possible).
Note
1• The subwoofer output depends on the settings you made in
Speaker setting
on page 51. However, if
SP
B
is selected above,
no sound is heard from the subwoofer (the LFE channel is not downmixed).
• Depending on the
Surround back speaker setting
on page 46 output from the surround back pre-out terminals may change.
• All speaker systems (except
SB 2ND Z
connections) are switched off when headphones are connected.
ACOUSTIC
EQ
QUICK
SETUP
SYSTEM
SETUP
RETURN
SPEAKERS
BAND
TONE
INPUT
ATT
EXTENDED
MODE
TUNING
/STATION
TUNER
EDIT
FL DIMMER
MULTI JOG
VSX_815-915.book.fm 71 ページ ２００５年３月１日 火曜日 午前１０時２２分