Filter
Top Products
Additional information
14
79
En
English
Français
Deutsch
Nederlands
Italiano
Español
Considerable noise in radio
broadcasts.
• Tune in the correct frequency.
• Connect the antenna (refer to page 21).
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
• Connect an outdoor FM antenna (refer to page 21).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to
page 21).
• Turn off the equipment causing the noise or move it away from the
receiver.
• Move antennas farther away from equipment causing the noise.
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 21).
No sound from surround or
center speakers.
• Connect the speakers properly (refer to page 22).
• Refer to
Speaker setting
on page 51 to check the speaker settings.
• Refer to
Channel level
on page 52 to check the speaker levels.
No sound from surround
back speakers.
• Refer to
Speaker setting
on page 51 to check the surround back
speaker settings.
• Refer to
Channel level
on page 52 to check the speaker levels.
• Refer to
Using the surround back channel (Extended mode)
on
page 41 to make sure the Extended mode and the sound mode are set
for surround back sound.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have an
LFE channel.
• Switch the subwoofer setting in
Speaker setting
on page 51 to
YES
or
PLUS
.
• Switch the
LFE Attenuator Setup
on page 77 to
LFEAT 0
or
LFEAT
10
.
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
Sound is produced from
other components, but not
from LD or DVD player.
• Set the
SIGNAL SELECT
to
AUTO
,
DIGITAL
or
ANALOG
according
to the type of connections made. (refer to page 40).
• Set the digital input settings correctly (refer to page 75).
• Make digital connections (refer to page 16) and set the
SIGNAL
SELECT
to
DIGITAL
(refer to page 40).
• Refer to the instruction manual supplied with the DVD player.
Problem
Remedy
VSX_815-915.book.fm 79 ページ ２００５年３月１日 火曜日 午前１０時２２分