Pioneer SX-LX03 Stereo Receiver User Manual


 
Controls and displays 01
9
En
English
FrançaisDeutsch
Nederlands
Italiano Español
ANGLE*
Press to switch the BD-ROM or DVD-Video
camera angles.
23
DISPLAY
Displays RDS information (page 41).
Displays song playback information when
using the iPod function.
After set the remote control operation switch to
BD, press to display the disc information.
24 Remote control operation selector switch
Set to RECEIVER iPod to operate this system or
iPod, BD to
operate the Blu-ray disc player.
Putting the batteries in the remote
control
1 Open the battery compartment cover
on the back of the remote control.
2 Insert two AA/R6 batteries into the
battery compartment following the
indications (, ) inside the compartment.
3 Close the cover.
Caution
Incorrect use of batteries can result in hazards
such as leakage and bursting. Please observe
the following:
Don’t mix new and old batteries together.
Don’t use different kinds of battery
together — although they may look similar,
different batteries may have different
voltages.
Make sure that the plus and minus ends of
each battery match the indications in the
battery compartment.
Remove batteries from equipment that
isn’t going to be used for a month or more.
When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction’s rules
that apply in your country/area.
Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.
Using the remote control
Please keep in mind the following when using
the remote control:
Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.
Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
Replace the batteries when you notice a
fall off in the operating range of the remote.
Use within the operating range in front of
the remote control sensor on the display
unit, as shown.
SOUN
D RET
RIEV
ER
HDMI
PULL OPEN
7 m
30
30
LX03BD_1.book Page 9 Monday, July 28, 2008 2:12 PM