Filter
Top Products
Listening to your system 05
35
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Adjusting the bass and treble
Use the bass and treble controls to adjust the
overall tone.
1 Press to open the sound menu.
2 Select ‘
Tone
’ then press
ENTER
.
3 S
elect
‘
Bass/Treble
’ then press
ENTER
.
• Selecting Bass/Treble cancels the
Midnight and Quiet listening modes. These
modes cannot be used at the same time.
4 Use
/
to select ‘
Bass
’ or
‘
Treble
’; use
/
to adjust the sound then
press
ENTER
to confirm.
• Bass and Treble can be adjusted from
–6dB
to
+6dB
.
• When the Bass or Treble is set to
something other than 0dB, the TONE
indicator lights.
Boosting the bass level
There are two bass modes you can use to
enhance the bass in a source.
1
1 Press to open the sound menu.
2 Select ‘
Bass Mode
’ then press
ENTER
.
3 Select the desired Bass Mode
setting, then press
ENTER
to confirm.
Select between Off, Music, Cinema or Auto.
• When Bass Mode is set to Auto, the
setting (Music or Cinema) is selected
automatically to optimally match the audio
signal.
•The BASS MODE indicator lights when
Bass Mode is active.
Adjusting sound delay
Some monitors have a slight delay when
showing video, so the soundtrack will be
slightly out of sync with the picture. By adding
a bit of delay, you can adjust the sound to
match the presentation of the video.
There are a total of 60 steps (levels) that you
can adjust, with a total range of 200 msec.
1 Press to open the sound menu.
2 Select ‘
Sound Delay
’ then press
ENTER
.
3 Select the length of the delay in
sound, then press
ENTER
to confirm.
• This option is deactivated and not
displayed if you have Auto Delay set to On
in HDMI Setup (see Setting the Auto Delay
on page 51).
Note
1 The Bass Mode is not available when headphones are connected.
SOUND
VIDEO
SELECT
ENTER
ENTER
ENTER
SOUND
VIDEO
SELECT
ENTER
ENTER
SOUND
VIDEO
SELECT
ENTER
ENTER
LX03BD_1.book Page 35 Monday, July 28, 2008 2:12 PM