Filter
Top Products
Surround sound settings 08
45
En
English
FrançaisDeutsch
Nederlands
Italiano Español
2 Select ‘
Virtual SB
’, then press
ENTER
.
3 Select a setting.
Select one of the following:
• Vir.SB On – Virtual Surround Back is
always used (for example, on 5.1 encoded
material).
• Vir.SB Off – Virtual Surround Back mode
is switched off.
The V.SB indicator lights when Virtual
Surround Back is active.
4 Press to exit.
LFE Attenuate
Some Dolby Digital and DTS audio sources
include ultra-low bass tones.
Set the LFE attenuator as necessary to prevent
the ultra-low bass tones from distorting the
sound from the speakers.
1
Open the ‘Sound Setup’ menu.
2
Select ‘LFE ATT’, then press ENTER.
3 Select a setting.
Select one of the following:
• 0dB – The LFE is not limited, which is the
recommended value.
• -10dB – The LFE is limited by the respective
degree.
• LFE Off – No sound is output from the LFE
channel.
4 Press to exit.
DTS CD setting
If you play a DTS-encoded CD, you will need to
change this setting to hear the decoded signal.
1
Open the ‘
Sound Setup
’
menu.
2
Select ‘CD Type’, then press ENTER.
3 Select a setting.
Select one of the following:
• Normal CD – Use for playback of regular
audio CDs. Some DTS-encoded CDs will
output noise when played.
• DTS-CD – Use for playback of DTS-
encoded CDs, but note that the beginning
of regular CD tracks may be skipped.
4 Press to exit.
ENTER
ENTER
SETUP
TOOLS
ENTER
ENTER
ENTER
SETUP
TOOLS
ENTER
ENTER
ENTER
LX03BD_1.book Page 45 Monday, July 28, 2008 2:12 PM