Filter
Top Products
settings for the speaker over which you hear
the test tone are shown in the display.
Front speaker leftCenter speakerFront
speaker rightRear speaker rightRear
speaker leftSubwoofer
# Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
# The settings do not appear for speakers
whose size is set OFF.
3 Press q or r to adjust the speaker
output level.
Each press of q or r increases or de-
creases the speaker output level. +10 10 is
displayed as the level is increased or de-
creased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Press m to stop the test tone output.
5 Press BAND to return to the playback
display.
Notes
! If needed, select speakers and adjust their ab-
solute output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at SP Lev. Both provide the same re-
sults.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Press p and hold until SP Set appears
in the display, then press p to select
TA MODE.
2 Press m or n to select the time
alignment.
! INIT Initial time alignment (factory set-
ting)
! CUSTOM Adjusted time alignment that
you can create for yourself
! AUTO TA Time alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on the
next page.)
! OFF Turn the time alignment off
# To turn time alignment off, select TA :OFF.
# You cannot select AUTO TA if auto TA and EQ
has not been carried out.
# You cannot select ADJUSTMENT when
neither F/L nor F/R is selected in Posi.
3 Press BAND to cancel the time align-
ment mode.
Adjusting the time alignment
By adjusting the distance between each
speaker and a selected listening position, you
can insert delay times into the speaker output
to obtain a correct sound image and overall
level balance. Although this is automatically
achieved when you set the listening position,
the time alignment feature provides a fine ad-
justment.
1 Press p and hold until SP Set appears
in the display, then press p to select
Time A.
After SP Set is displayed, press p until
Time A appears in the display.
# You cannot select Time A when neither F/L
nor F/R is selected in Posi.
Digital Signal Processor
En
27
English
Section
07