Filter
Top Products
Event
38
Use the procedures in this section to configure alarm output duration and buzzer duration settings for when an event (site alarm, terminal alarm,
command alarm) occurs.
1 Click the [Event] button on the setup menu.
2 On the sub-menu that appears, click [Basic].
This displays the event action basic setup window.
3 Configure the settings for each item.
Refer to “Basic event settings” table for details about the
settings.
4 Click the [Set] button.
Basic event settings
♦Initial default
Basics
Item Settings Description
Alarm output Off / 2s♦ / 5s / 10s / 20s / 30s /
1min / Ext / Rec
Specifies the alarm output duration.
• Selecting [Ext] causes alarm output to continue until the
"Alarm [ALM]" button is clicked.
• Selecting [Rec] causes alarm output while event recording is
in progress.
Buzzer duration Off / 2s♦ / 5s / 10s / 20s / 30s /
1min / Ext / Rec
Specifies buzzer duration.
• Selecting [Ext] causes the buzzer to continue to sound until
the "Alarm [ALM]" button is clicked or the [BUZZER STOP]
button on the front panel is pressed.
• Selecting [Rec] causes the buzzer to sound while event
recording is in progress.