Filter
Top Products
8
If you have an outside VHF TV
antenna, you can use a signal splitter
with a 300-ohm output to connect
your stereo system and TV set to the
same antenna. Your local Ra-
dioShack store has a wide selection
of antennas, connectors, and split-
ters.
INSTALLING THE
REMOTE CONTROL’S
BATTERIES
The remote control requires two AAA
batteries (not supplied) for power.
For the best performance and long-
est life, we recommend alkaline
batteries, such as RadioShack Cat.
No. 23-555.
Follow these steps to install batter-
ies.
1. Press down and slide off the bat-
tery compartment cover.
2. Install the batteries as indicated
by the polarity symbols (+) and
(–) marked inside the compart-
ment.
3. Replace the cover.
Cautions:
• If you are not going to use the
remote control for a month or
more, remove its batteries. Bat-
teries can leak damaging chemi-
cals.
• Do not mix old and new batter-
ies, different types of batteries
(standard, alkaline, or recharge-
able), or rechargeable batteries
of different capacities.
Note:
If the remote control operates
erratically or does not work at all, re-
place both batteries.
CONNECTING TO
POWER
After you complete all connections,
plug the music system’s supplied
power cord into a standard AC outlet.
Warning:
To prevent electric shock,
the power cord plug’s blades are po-
larized (one blade is wider than the
other) and fit a polarized AC outlet
only one way. If you have difficulty in-
serting the plug, do not force it. Turn
it over and reinsert it.
The STAND BY indicator lights, and
AM
12:00
flashes on the display
(see “Setting the Clock” on Page 11).
13-1289.fm Page 8 Wednesday, July 14, 1999 6:09 PM