Filter
Top Products
97
Advanced Setup
—Continued
Setting Speakers A and Speakers B
If you’re using Speakers B, you can choose whether or
not to use the subwoofer, center, surround, and surround
back speakers with the Speakers A and Speakers B con-
figurations independently. You cannot choose whether or
not to use the front speakers.
Use the remote controller’s [SP A] or [SP B] button to
select Speakers A or Speakers B, respectively.
13
Press the Down [ ] button to
display the bottom half of the
Speaker Config screen.
Notes:
• The bottom half of the Speaker Con-
fig screen can only be displayed
when the Speakers Type Front B set-
ting is set to something other than
Not Use (page 51).
•You can switch between the Speak-
ers A and Speakers B settings on
either half of the Speaker Config
screen.
14
Use the Up and Down [ ]/[ ]
buttons to select “Subwoofer,”
and then use the Left and Right
[ ]/[ ] buttons to select:
Not Use:
Select if you don’t want to
use the subwoofer with
Speakers A or Speakers B.
Use:
Select if you do want to use
the subwoofer with Speakers
A or Speakers B.
Note:
• Cannot be set if Subwoofer (step 5) is
set to No.
These settings are not set automatically by the Auto-
matic Speaker Setup function (see page 61).
ENTER
2-2.Speaker Config
Speakers A
Subwoofer
Not Use
Front Use
Center Not Use
Surround Use
Surr Back Use
ENTER
ENTER
15
Use the Up and Down [ ]/[ ]
buttons to select “Center,” and
then use the Left and Right
[ ]/[ ] buttons to select:
Not Use:
Select if you don’t want to
use the center speaker with
Speakers A or Speakers B.
Use:
Select if you do want to use
the center speaker with
Speakers A or Speakers B.
Note:
• Cannot be set if the currently
selected speakers (Speakers A or
Speakers B) is set to BTL (page 51),
or Center (step 7) is set to None.
16
Use the Up and Down [ ]/[ ]
buttons to select “Surround,” and
then use the Left and Right
[ ]/[ ] buttons to select:
Not Use:
Select if you don’t want to
use the surround speakers
with Speakers A or Speakers
B.
Use:
Select if you do want to use
the surround speakers with
Speakers A or Speakers B.
Note:
• Cannot be set if the currently
selected speakers (Speakers A or
Speakers B) is set to BTL (page 51),
or Surround (step 8) is set to None.
17
Use the Up and Down [ ]/[ ]
buttons to select “SurrBack,” and
then use the Left and Right
[ ]/[ ] buttons to select:
Not Use:
Select if you don’t want to
use the surround back speak-
ers with Speakers A or Speak-
ers B.
Use:
Select if you do want to use
the surround back speakers
with Speakers A or Speakers
B.
Note:
• Fixed at Not Use if Surround (step
16) is set to Not Use.
• Cannot be set if Speaker Type Front
B is set to Bi-Amp or BTL (page 51),
SurrBack is set to None (step 9), or
Powered Zone 2 is being used
(page 121).
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER