Filter
Top Products
115
NET/USB
—Continued
Random Playback
To play songs in random order, while the list of songs is
displayed, press the [RANDOM] button. All of the songs
in the current folder will be played in random order.
When all of the songs in the folder have been played
once, they’ll all be played again in a different random
order. To cancel random playback, press the [RAN-
DOM] button again.
Random playback supports up to 9,999 songs per folder.
If a folder contains more than this, songs over 9,999 are
not included in random playback.
Repeat Playback
The Repeat function can only be set while the PLAY
screen is displayed.
To play songs repeatedly, during playback (or while
playback is paused or stopped), press the [REPEAT] but-
ton repeatedly to select: Repeat1, Repeat, All, or Off.
In Repeat1 mode, the current song is played repeatedly.
In Repeat mode, all of the songs in the current folder are
played repeatedly.
In All mode, all of the songs on the USB mass storage
device (in the same partition) are played repeatedly.
To cancel repeat playback, press the [REPEAT] button
repeatedly to select Off.
Notes:
• If you connect a USB hard disk drive to the AV
receiver’s USB port, we recommend that you use its
AC adapter to power it.
• Do not connect the AV receiver’s USB port to a USB
port on your computer. Music on your computer can-
not be played through the AV receiver in this way.
• The AV receiver supports USB MP3 players that sup-
port the USB Mass Storage Class standard, which
allows USB storage devices to be connected to com-
puters without the need for special drivers or software.
Note that not all USB MP3 players support the USB
Mass Storage Class standard. Refer your USB MP3
player’s instruction manual for details.
• Protected WMA music files on an MP3 player cannot
be played.
• Onkyo accepts no responsibility whatsoever for the
loss or damage to data stored on a USB mass storage
device when that device is used with the AV receiver.
We recommend that you back up your important
music files beforehand.
• MP3 players containing music files that are managed
with special music software, and iPods containing
music files managed with iTunes are not supported.
• Operation with all USB mass storage devices includ-
ing the ability to power them is not guaranteed.
• Do not connect your USB mass storage device via a
USB hub. The USB mass storage device must be con-
nected directly to the AV receiver’s USB port.
• If the USB mass storage device contains a lot of data,
the AV receiver make take a while to read it.
4
Use the Up and Down [ ]/[ ]
buttons to select a USB mass
storage device, and then press
[ENTER].
A list of the device’s contents appears.
To open a folder, use the Up and Down
[ ]/[ ] buttons to select it, and then
press [ENTER].
5
Use the Up and Down [ ]/[ ]
buttons to select a music file, and
press the [ENTER] or Play [ ]
button to start playback.
Playback starts and the following
screen appears.
To return to the previous menu during
playback, press the [Return] button.
To stop or pause playback, press the
Stop [ ] or Pause [ ] button, respec-
tively.
To select the next song, press the Next
[] button. To select the beginning of
the current song, press the Previous
[] button. To select the previous
song, press the Previous [ ] button
twice.
ENTER
ENTER
USB Storage 1/15
Folder1
Folder2
01_Song_Track1.WMA
02_Song_Track2.WMA
03_Song_Track3.WMA
04_Song_Track4.WMA
05_Song_Track5.WMA
06_Song_Track6.WMA
07_Song_Track7.WMA
08_Song_Track8.WMA
ENTER
ENTER
or
PLAY 4/15
USB Storage
02_Song_Track2.WMA
WMA 160kbps 16bit/44.1kHz
RETURN
00:10
--:--:--