Filter
Top Products
50
Turning On the AV Receiver
For non-North American models:
To completely shut down the AV receiver, set the [POWER] switch to the OFF
position ( ).
STANDBY
ZONE 2
ZONE 3
OFF TONE HDMI OUT
DIGITAL INPUT
ZONE 2
ZONE 3
LEVEL
PHONES
STEREO THX
LISTENING MODE
STANDBY/ON
CBL/SATVCR/DVR
DVDAUDIO SELPURE AUDIO
STANDBY/ON
CBL/SATVCR/DVR
DVDAUDIO SELPURE AUDIO
STANDBY
READY
ZONE 2
ZONE 3
OFF TONE HDMI OUT
DIGITAL INPUT
ZONE 2
ZONE 3
LEVEL
PHONES POWER
ON OFF
STEREO THX
LISTENING MODE
STANDBY/ON STANDBY/ON
POWER
INPUT SELECTOR
ON STANDBY
DIMMER
CDR/MD/DOCK
SAT
TAPE/AMP
SLEEP
MACRO
REMOTE MODE
--
/
---
10 11 12
TV
TV CH
TV VOL
DVD
AUX1 AUX
2
GAME/TV
CBL/SATVCR/DVR
D. TUN
CD
TUNER
TAPE
PHONO
TV
VCR
CABLE
NET/USB
DVD
RECEIVER
CD
+
-
123
ZONE
3
ZONE
2
INPUT
+10
0
CLEAR
123
456
789
NET/USB
ON
RECEIVER
STANDBY
STANDBY indicator
• North American model • Other models
STANDBY indicator
Turning On and Standby
1
Set the [POWER] switch to the ON position ( ).
(Skip this step if you have the North American model.)
The AV receiver enters Standby mode, and the STANDBY indicator comes on.
2
On the AV receiver, press the [STANDBY/ON] button.
On the remote controller, press the [RECEIVER] REMOTE MODE button,
followed by the [ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
Pressing the remote controller’s [ON] button again will turn on any components con-
nected via .
To turn the AV receiver off, press the [STANDBY/ON] button, or press the remote
controller’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent
any loud surprises the next time you turn on the AV receiver, turn down the volume
before you turn it off.
POWER
ON OFF
RECEIVER
STANDBY/ON
ON
Remote
controller
AV receiver
or
Up and Running in a Few Easy Steps
To get your system up and running with the minimum of fuss, here’s a few pointers to help you configure the AV
receiver before you use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey MultEQ XT)” on page 61.
■ Did you connect your TV to an HDMI OUT or COMPONENT
VIDEO OUT?
If you did, see “HDMI Monitor Setup” on page 52.
■ Did you connect a component to an HDMI input,
component video input, or digital audio input?
If you did, see “HDMI Input Setup” on page 54, “Component Video
Input Setup” on page 56, or “Digital Input Setup” on page 58 respec-
tively.
■ Did you connect an Onkyo MD recorder, CD recorder, or RI
Dock?
If you did, see “Changing the Input Display” on page 57.
OPTICAL
COAXIAL
Y
P
B
PR
HDMI
OUT IN
TAPE
MD recorder, CD recorder,
RI Dock