Filter
Top Products
95
Advanced Setup
—Continued
5
Use the Up and Down [ ]/[ ]
buttons to select “Subwoofer,”
and then use the Left and Right
[ ]/[ ] buttons to select:
Yes:
Select if a subwoofer is con-
nected.
No:
Select if no subwoofer is con-
nected.
Note:
• The same setting is used for Speakers
A and Speakers B.
6
Use the Up and Down [ ]/[ ]
buttons to select “Front,” and
then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
Notes:
• This setting can be set independently
for front Speakers A and front Speak-
ers B.
• Fixed at Full Band if Subwoofer
(step 5) is set to No.
7
Use the Up and Down [ ]/[ ]
buttons to select “Center,” and
then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
If no center speaker is connected, select
None.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if the currently
selected speakers (Speakers A or
Speakers B) is set to BTL (page 51).
• Cannot select Full Band if Front
(step 6) is set to anything other than
Full Band.
•For Speakers B, if any channel is set
to Full Band, Center is fixed at Full
Band.
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
8
Use the Up and Down [ ]/[ ]
buttons to select “Surround,” and
then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
If no surround left and right speakers
are connected, select None.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if the currently
selected speakers (Speakers A or
Speakers B) is set to BTL (page 51).
• Cannot select Full Band if Front
(step 6) is set to anything other than
Full Band.
9
Use the Up and Down [ ]/[ ]
buttons to select “Surr Back,”
and then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
If no surround back speakers are con-
nected, select None.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if Speaker Type Front
A or Front B is set to Bi-Amp or BTL
(page 51), Surround is set to None
(step 8), or Powered Zone 2 is being
used (page 121).
• Cannot select Full Band if Surround
(step 8) is set to anything other than
Full Band.
10
Use the Up and Down [ ]/[ ]
buttons to select “Surr Back Ch,”
and then use the Left and Right
[ ]/[ ] buttons to select:
1ch:
Select if one surround back
speaker is connected.
2ch:
Select if two (left and right)
surround back speakers are
connected.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if Speaker Type Front
A or Front B is set to Bi-Amp or BTL
(page 51), SurrBack is set to None
(step 9), or Powered Zone 2 is being
used (page 121).
Continue with step 11 on the next page.
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER