Onkyo TX-SR800 Stereo System User Manual


 
75
Troubleshooting guide
If one of the messages shown below appears
Not available with headphones use
Operation not allowed because headphones are plugged into the TX-
SR800.
Not available with Multichannel use
Operation not allowed while the multi-channel output is being used.
Not available in this Sp Config
Will not work with the current speaker configuration settings.
Not available in Zone 2 mode
Setting not allowed because the Zone 2 mode is turned on.
Only available with Dolby D
No setting other than Dolby Digital can be set.
Not available in this Listening mode
Will not work with the current listening mode.
Not available with this signal
The listening mode cannot be selected with the current input source.
Not available in PURE AUDIO mode
Will not work with the PURE AUDIO mode.
Surr Back/Zone 2 setting is Surr Back
Operation not allowed because the setting is Surr Back.
Surr Back/Zone 2 setting is Zone 2
Operation not allowed because the setting is Zone 2.
Not available with this Surr Back/Zone 2 setting
Will not work with the current setting.
Not available with Muting
Operation not allowed because the muting is activated.
Zone 2 is not On
Will not work because the Zone 2 has not been turned on.
Also refer to the respective instruction manuals of the CD player,
DVD player, video cassette recorder, TV monitor, etc., that compose
your entertainment system.
The TX-SR800 contains an internal microcomputer that performs
high-level operations. However, on extremely rare occasions, noise
or interference from an external source or static electricity may cause
faulty operation. If this occurs, unplug the power cord from the wall
outlet, wait five or more seconds, and then plug it back in. This
should correct the situation.
* To reset the surround mode and other settings to the factory
default settings, hold down the VIDEO 1 button with the TX-
SR800 turned on and then press the STANDBY/ON button.
CLEAR appears in the front display and the TX-SR800 enters
the standby state.