Filter
Top Products
18
Connecting to Audio/Video equipment
7. Connecting a DVD recorder or other digital video recording
device (VIDEO 2)
Using RCA video cables, connect the video output jack (composite)
of the device to the VIDEO 2 VIDEO IN jack of the TX-SR800 and
connect the video input jack of the device to the VIDEO 2 VIDEO
OUT jack of the TX-SR800. Or if the device has S video input and
output jacks, connect them to the VIDEO 2 S VIDEO IN and OUT
jacks of the TX-SR800 using S video cables. Or if the device has
component video outputs, connect them to one of the banks of
COMPONENT VIDEO INPUT jacks on the TX-SR800.
With the initial settings of the TX-SR800, the VIDEO 2 input
source is set for the COMPONENT VIDEO INPUT 2 jacks.
If you connect the device to the COMPONENT VIDEO INPUT 1
jacks, this must be changed at Setup Menu → Input Setup → Video
Setup → Component Video (see page 48).
Using RCA audio cables, connect the audio output jacks of the
device to the VIDEO 2 AUDIO IN jacks of the TX-SR800 and
connect the audio input jacks of the device to the VIDEO 2 AUDIO
OUT jacks of the TX-SR800. Make sure that you properly connect
the left channels to the L jacks and the right channels to the R jacks.
If the device has a digital output, connect it to either the DIGITAL
INPUT COAX jack or DIGITAL INPUT OPT jack of the TX-
SR800 depending on the type of connector on the device.
With the initial settings of the TX-SR800, the VIDEO 2 input
source is set for digital input at the COAX 3 jack.
If the digital connection is made at a different jack, this must be
changed at Setup Menu → Input Setup → Digital Setup (see page
46).
PRE
FRONT
SUB
SURR
R
GND
SURR
BACK/
ZONE 2
R
FRONT
SUB
SURR
SURR
BACK
R
R
OPT
OPT
COAX
DIGITAL
INPUT
DIGITAL
OUTPUT
2
1
2
3
1
3
AUDIO
VIDEO
S VIDEO
MONITOR
OUT
IN
IN
IN
IN
IN
ZONE 2
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO
VIDEO
S VIDEO
COMPONENT
VIDEO
Y
P
B
P
R
OUTPUT
INPUT 1
Y
P
B
P
R
INPUT 2
Y
P
B
P
R
R
L
OUT
OUT
OUT
PHONO
UDIO
L
CD
TAPE
L
UDIO
IN
OUT
AM
FM
75
R
L
TENNA
P
R
P
B
Y
If the device has a digital input, connect it to the DIGITAL OUTPUT
OPT jack of the TX-SR800 for digital recording of the REC OUT
signal from the TX-SR800.
Note:
The output from the DIGITAL OUTPUT jack of the TX-SR800 is
only the digital signal input to the DIGITAL INPUT jack.
7. DVD recorder, other digital video
recording device (VIDEO 2)
Digital audio input (optical)
Digital audio output (coaxial)
S Video input
Video input
Analog audio
output
Video output
S Video output
Component video output
R (red)
L (white)
R (red)
L (white)
Analog audio
input
: Signal flow