68
Advanced Setup
—Continued
Audio TV Out
This setting determines whether audio
received by an HDMI input is output by the
HDMI OUT. You may want to change this
setting to On if your TV is connected to the
HDMI OUT and you want to listen to audio
from an HDMI component through your TV’s
speakers instead of the HTX-22HD’s speak-
ers. Normally, this should be set to Off.
Off:
HDMI audio is not output (default).
On:
HDMI audio is output.
Notes:
• If On is selected and the signal can be out-
put by the TV, the HTX-22HD’s speakers
will output no sound.
• When TV Control is enabled, this setting is
set to Auto.
•With some TVs and input signals, no sound
may be output even if On is selected.
• When the Audio TV Out setting is set to
On, or TV Control is set to Enable and
you’re listening through your TV’s speak-
ers (see page 25), if you turn up the HTX-
22HD’s volume control, the sound will be
output by the HTX-22HD’s speakers. To
stop the HTX-22HD’s speakers producing
sound, change the settings, change your
TV’s settings, or turn down the HTX-
22HD’s volume.
Lip Sync
The Lip Sync function can automatically syn-
chronize HDMI audio and video that’s gotten
out of sync due to the complex digital video
processing being performed by your HDMI-
compatible TV. With HDMI Lip Sync, the
audio delay required to synchronize the audio
and video is calculated and applied automati-
cally by the HTX-22HD.
Disable:
HDMI lip sync disabled.
Enable:
HDMI lip sync enabled.
Notes:
• This function works only if your HDMI-
compatible TV supports HDMI Lip Sync.
•You can check the amount of delay being
applied by the HDMI Lip Sync function on
the A/V Sync screen (see page 65).
x.v.Color
With this setting you can enable or disable
x.v.Color. To use x.v.Color, the HDMI source
and HDMI TV must both support x.v.Color.
Disable:
x.v.Color disabled.
Enable:
x.v.Color enabled.
Control
This function allows RIHD-compatible com-
ponents connected via HDMI to be controlled
with the HTX-22HD.
Disable:
RIHD disabled.
Enable:
RIHD enabled.
Notes:
• RIHD, which stands for Remote Interactive
over HDMI, is the name of the system con-
trol function found on certain Onkyo com-
ponents. The HTX-22HD can be used with
CEC (Consumer Electronics Control),
which allows system control over HDMI
and is part of the HDMI standard. CEC
provides interoperability between various
components, however, operation with com-
ponents other than RIHD-compatible com-
ponents and recommended components
cannot be guaranteed.