Filter
Top Products
68
Advanced Setup—Continued
You can set the input level for each input source. This is
useful if some of your AV components are louder or qui-
eter than others.
While this menu is shown onscreen, you can select each
input source and set the levels while listening to and
comparing them.
This section explains the items on the Miscellaneous
Setup menu.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
IntelliVolume
1
Press the [RECEIVER] or [AMP]
button followed by the [SETUP]
button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “5. Input
Setup,” and then press [ENTER].
The Input Setup menu appears.
3
Use the INPUT SELECTOR but-
tons on the remote controller to
select the input source that you
want to set.
4
Use the Up and Down [ ]/[ ]
buttons to select
“a. IntelliVolume.”
If a component is too loud compared to
your other components, use the Left
[ ] button to adjust the level. If it’s too
quiet, use the Right [ ] button.
• The level can be set from –12 dB to
+12 dB.
SETUP
RECEIVER
AMP
5.Input Setup
--------DVD/MCH---------
a.IntelliVolume: 0dB
Listening Mode Preset
b.Ana/PCM:Last Valid
c.Dolby D:Last Valid
d.DTS :Last Valid
e.D.F.2ch:Last Valid
f.Mono :Last Valid
g.MCH Ana:Last Valid
V1 V2 V3
C
DTAPE TUNER
DVD
123
6
789
V4
4
Volume Setup/OSD Setup
1
Press the [RECEIVER] or [AMP]
button followed by the [SETUP]
button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select
“6. Miscellaneous Setup,” and
then press [ENTER].
The Miscellaneous Setup menu
appears.
3
Use the Up and Down [ ]/[ ]
buttons to select the settings,
and use the Left and Right [ ]/
[ ] buttons to set them.
The settings are explained on page 69.
4
When you’ve finished, press the
[SETUP] button.
The setup menu closes.
SETUP
RECEIVER
AMP
6.Miscellaneous Setup
------------------------
a.MaximumVolume: Off
b.PowerOnVolume: Last
c.Immediate Display
:Normal
SETUP