Filter
Top Products
42
Display messages
Message Explanation Pages
Open Disc tray is opening. 17
Welcome Disc tray is closing. 17
Rec Setup Setting initial settings for recording. Please wait. 25
TOC Reading Reading the table of contents recorded on the disc. Please wait. 17
PMA Writing Recording TOC data to the disc PMA (Program Memory Area). 18
Never turn off the power while this message is displayed.
Erase Last? Erasing the last track. 35
To erase the last track, press the YES button or the MULTI JOG dial.
Erase All? Erasing all tracks. 35
To erase all track, press the YES button or the MULTI JOG dial.
TOC Erase? Erasing the TOC from a finalized disc to return it to the 36
unfinalized condition. To erase the TOC, press the YES button.
Ers: (✳ - ✳) ? Erasing from track selected to last track. 35
To erase, press the YES button or the MULTI JOG dial.
Initialize? Erase all data from disc. To erase all data, press the YES button or 37
the MULTI JOG dial.
Name In? Asking if you are entering a disc name, artist name, and track names. 28
To enter names, press the YES button (or the MULTI JOG dial).
If during operation a malfunction occurs or an improper operation is performed, the corresponding
message will appear. For a description of these messages, refer to the explanations on the following pages.
Other Information
Guide to the serial copy
management system
You cannot use digital recording to create a second-
generation copy, a copy of a copy created through
digital recording, with a CD-R or CD-RW. This is
because the unit conforms to the Serial Copy
Management System and permits only one
generation of digital-to-digital copying (the
recording of the original digital signals as they are).
The Serial Copy Management System is based on the
following three rules.
Principle 1
Digital-to-digital copying can be used to create a
copy of a CompactDisc (CD), Digital Audio Tape
(DAT), MiniDisk (MD), etc. with a CD-R or CD-RW.
However, digital-to-digital copying is not allowed to
create a copy of a CD-R or CD-RW that has been
created through digital-to-digital copying.
Principle 2
Digital-to-digital copying can be used to create a
copy of a CD-R or CD-RW that contains the songs
from analog records, FM radio programs, etc. you
recorded using the unit. However, digital-to-digital
copying is not allowed to create a copy of a CD-R or
CD-RW that has been created through digital-to-
digital copying. When two CD recorders are
connected via the analog input and output
terminals, however, recording can be performed
beyond this restriction.
Principle 3
With a DAT deck or a CD recorder that supports the
sampling frequencies of 32 kHz and 48 kHz, digital-
to-digital copying can be used to record the digital
sound from satellite broadcast. (This CD recorder
supports these sampling frequencies.) In this case,
digital-to-digital copying is allowed to create a
second-generation copy. However, with some BS
tuners, second-generation copy may not be
produced.
* When CD recorders are connected using analog
terminals, the number of dubbings is not
limited.
Rules concerning digital recording