Filter
Top Products
22
Synchronous recording by input signal
detection (Signal synchronous recording)
DUAL
DIGITAL
INPUT
ANDBYST
OFF
ON
STANDBY/ON
POWER
AUDIO
CD
RECORDER
DX
-
R
700
MEMORY CLEAR
REPEAT FINALIZE
STOP PLAYPAUSE
REC
PHONES LEVEL
MIN MAX
PHONES
YES
INPUTDISPLAY
EDIT/
NO
PUSH TO
ENTER
MULTI JOG
STANDBY/
ON OPEN
/
CLOSE
RANDOMMEMORY REPEAT
NAMEABC DEF
231
SCROLL
GHI MNOJ
K
L
456
CLEAR
DISPLAY
ENTER
PQRS TUV W
XYZ
10
/
0
>
10
789
REC
o
REC
o
REC
INPUT
INPUT
2 Start playback of the recording source.
3 Press the o REC button.
“Rec Setup” appears in the display followed by
the time display.
1 Repeatedly press the INPUT button
and select the desired input signal.
Select “Digital In 1,” “Digital In 2,” or “Analog
In” for the input source.
This method allows you to start recording in
synchronization with the input signals from the
Onkyo products that are not equipped with an z
connector or other manufacturer's products. When
recording with the Onkyo products equipped with
an z connector, refer to “Synchronous recording”
on page 24.
Notes:
Note the following when using synchronous
recording for digital input sources.
• Sources other than CDs, MDs, DATs, and DCCs
cannot be recorded.
• DATs and DCCs cannot be recorded if no start
ID is present before audio contents.
• Synchronous recording uses a sub-code signal
that is contained in the digital output from most
player components, and therefore there may be
some CD players, MD recorders, or the like
where digital synchronous recording is
impossible.
Preparation
• Turn on the DX-R700 (see page 16).
• Place a recordable CD-R or CD-RW in the DX-
R700 (see page 17).
• Verify that the input dial and recording selection
button of the amplifier are set to the position of
the recording source.
Proceed to step 6 if you do not wish to adjust
the recording level.
Proceed to step 3 if you do not wish to adjust
the recording level.
REC
REC
DX-R700 RC-448C