Filter
Top Products
23
Note:
If “Check Level” flashes and recording does not
start, then the recording source was likely already
playing and not allowing recording to start. First stop
the recording source and then resume operations.
7 Verify that “Signal Wait” is flashing
together with the time display and
then start the playback of the
recording source.
Recording starts as soon as the DX-R700
receives signals from the recording source.
4 Adjust the recording level.
Refer to page 21, step 4 “Adjust the recording
level.”
5 Stop the playback of the recording
source.
6 Press the o REC button.
The DX-R700 enters the input standby state,
“Signal Rec” appears in the display, and then
“Signal Wait” appears flashing alternately with
the time display.
Auto finalization
To use auto finalization, press the FINALIZE button
repeatedly during recording until “Auto On”
appears. (The FINALIZE indicator appears flashing.)
Finalization starts automatically when the DX-R700 is
set in the state of “Signal Wait” for 1 minute after
interruption of the input signal.
• If “Name Disc” appears when you press the
FINALIZE button
You cannot use auto finalization. This is
because the disc has track names but it has no
disc name.
Follow the steps below to finalize.
1. Enter a disc name after recording completes
(see page 28).
2. Press the FINALIZE button to finalize the disc
(see page 33).
To cancel auto finalization
Press the FINALIZE button repeatedly until “Auto
Off” appears. (The FINALIZE indicator disappears.)
Notes on the signal synchronous recording
• When the level sync function is turned on
during analog recording, the track numbers are
updated automatically as soon as audible sound
is detected after 2 seconds or more of silence.
• If placed in the state of “Signal Wait” for 1
minute, the DX-R700 enters the recording
standby state with the signal synchronous
recording canceled.
When the auto finalization is turned on,
finalization automatically starts.
• When “D.In Unlock” appears in the front display
during the signal synchronous recording (digital
input), the DX-R700 cancels the recording
mode and enter to the recording standby state.
• When the signal synchronous recording is
performed with an Onkyo CD player connected
to the DX-R700 using the z terminal, pressing
the stop button on the CD player will
not stop the DX-R700, but place it in the
“Signal Wait” state.
REC
REC
DX-R700 RC-448C
Synchronous recording by input signal detection
(Signal synchronous recording)