Filter
Top Products
26
Using the level sync function
3 Press the MULTI JOG dial.
Pressing the YES button provides the same
operation.
The level sync function turns off. Press the EDIT/
NO button to return to the previous setting.
2 Press the MULTI JOG dial.
Pressing the YES button provides the same
operation.
The current setting appears. The current setting
is given on the left side (for the display given
below, the current setting is “On”).
Using the level sync function
During analog recording, the track numbers are
assigned automatically since the level sync function is
turned on. Even so, you can press the o REC (or the
remote controller o REC button) to assign the track
numbers manually. To disable the automatic
assignment of track numbers during recording, turn
off the level sync function.
Turn off the level sync function and assign the track
numbers manually, if the numbers are not
automatically updated due to the situations as
follows:
For analog recording
The level sync function uses the recording source
level to detect the end and beginning of tracks.
Therefore, in the cases given below, the track
numbers may not be properly assigned.
• The recording on the cassette tape is poor (e.g.,
the space between songs contains much noise).
• With music such as classical music where there
may be very low volumes.
• Where the space between songs is extremely
short.
• If the signal at the tuner is weak (excessive
noise).
• When recording from turntables.
For digital recording
• When digitally recording satellite broadcasts, the
track numbers may not be assigned properly. If
this occurs, turn off the level sync function and
set the track numbers manually (see page 21).
• If the time between tracks is extremely short, the
track numbers may not be assigned properly.
1 During recording or while in the
recording standby state, press the
EDIT/NO button and turn the MULTI
JOG dial until “Level Sync?” appears.
To return to automatic assignment of track
numbers
Switch the setting to On.
Follow the steps 1 through 3. “Off → On?” should
appear in step 2, “L.Sync On” in step3.
PUSH TO
ENTER
MULTI JOG
PUSH TO
ENTER
MULTI JOG
EDIT/
NO
PUSH TO
ENTER
MULTI JOG