Filter
Top Products
8
Using the remote controller
■ Using the RC-414C remote
controller that is supplied with the
Onkyo Separate Collection R-805X
components to operate the CDR-
205X.
Installing the remote controller
batteries
1 Push the battery cover in the direction of the
arrows shown and remove it.
Using the remote controller
When operating the remote controller, point it toward the
remote control sensor of the Tuneramplifier.
CDR-205X
Tuneramplifier
Remote
control
sensor
Note:
• If the remote control sensor is subjected to
direct sunlight or inverted fluorescent light,
operation of the remote controller may be
adversely affected.
• Use of another remote controller nearby or
using the remote controller near equipment that
uses infrared light may cause operational
interference.
• Do not put objects on the remote controller. A
button on the remote controller may remain
pressed and drain the batteries.
• Make sure the CDR-205X is not placed behind
colored glass doors. Placing the CDR-205X
behind such doors may prevent proper
operation of the remote controller.
• If there is an obstacle between the remote
controller and the remote control sensor, the
remote controller will not operate.
2 Install the supplied (or AA, R06, or UM-3-sized)
batteries into the battery compartment being
careful not mistake the polarity (follow the
polarity diagram inside).
3 Replace the battery cover.
Note:
• Do not mix new batteries with old batteries or
different kinds of batteries.
• To avoid corrosion, remove the batteries if the
remote controller will not be used for a long
time.
• Immediately remove dead batteries to avoid
damage to the remote controller from corrosion.
If the remote controller begins to operate
improperly, remove the old batteries and replace
them with two new batteries.
• The life of the supplied batteries is approx. 1
year, though this value may vary depending on
usage.
30°
5m
30°