Filter
Top Products
ENHANCED STEREO
Please refer to the same description about “ENHANCED STEREO” under the “LISTENING MODE” of the
Main Menu discussions.
DISPLAY SETUP
The Vacuum Fluorescent Display (VFD) and On-Screen Display (OSD) can be shown in various ways by
navigating through the parameters at the “Display Setup” menu. Use a combination of [ ] or [ENTER]
and [ ] keys to step through the “Display Setup” menu items.
NOTE
The congurations set forth at “Display Setup” are carried over whenever it is enabled during A/V
Preset setting. Please see also the section below about “A/V PRESETS”.
VACUUM FLUORESCENT DISPLAY VFD
Display: Select “On” to display all applicable data or characters at the VFD. Nothing will be shown
at VFD if “Temp” is selected. At “Temp” setting however, whenever any of the front panel controls or
their corresponding keys in the remote control are activated, the appropriate VFD characters will be
shown temporarily and then fade away. Note that if any of the Zones are at powered state, they will be
continually shown at VFD even at “Temp” setting.
Dimmer: If it is desired to reduce the brightness of the VFD, set Dimmer to “Dim”. Otherwise, select
“Bright” to return to normal VFD brightness.
Line 1, Line 2: The VFD shows two main lines of data or characters. Line 2 is the line of data or
characters located at the lower bottom of the VFD while directly above it is Line 1. For both lines, one
can select which display could be shown by choosing through the following
Main Source: Shows the active Source.
Volume: Current Volume level is shown.
Listening Mode: Selected Listening Mode is shown.
Audio Src Format: Shows the audio format detected at the active Source.
Zone 2-Zone 3-Zone 4 Source: The assigned Source for the applicable Zone is shown.
O: Select “O” if it is desired not to show any data at the applicable Line.
Temp Line: Choose between Line 1 and Line 2 as the desired line where VFD will be temporarily
shown if “Temp” is selected at “Display” option as described above.
ONSCREEN DISPLAY OSD
Temp Disp: This applies to the OSD that is temporarily shown at video out whenever any of the front
panel controls or their corresponding keys in the remote control is activated. Set to “On” if it is desired
to show the applicable OSD at the monitor/TV; otherwise, select “O”.
OPERATION
USING THE T 175 SETUP MENU
28
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ