Filter
Top Products
Customising 562 using Config 21
562 User Guide
Setting up sources
For each of the twelve source selection keys on the Remote control you
choose a display Logo and a primary physical input connection – and by
implication – signal type. In addition for digital sources you may set up a
secondary analogue input connection that 562 may use for the analogue
tape copy signal. (This is necessary if you do not have the DAC option
fitted or externally connected – see page ??).
Normally as shown we set the CD key to give a CD display with the D1
(Digital 1) input selected. You may however wish to display CD1 for your
main CD player and to connect it to D2 or one of the analogue inputs.
A full list of possible logos and their meanings is:
Source Logo Source Logo Source Logo
CD CD S-VHS SV DAB DB
Radio RD Betamax
βm
Dig. Sat. DS
LP LP Camera Ca ADC AD
Tape 1 T1 Video 8 V8 R-Reel RR
Tape 2 T2 CD-Video CV FM tuner FM
CDR Cr CD-I CI AM tuner AM
Cable Cb CD trans. C1 MW tuner MW
Teletext TX Photo CD PC SW tuner SW
VCR 1 V1 CD Lib. CL LW tuner LW
VCR 2 V2 Jukebox JB Line Li
Laserdisc LD CD-ROM Rm Mic. Mi
Satellite SA DAT DT Aux Au
CDX C2 DCC DC Mixer Mx
78 rpm 78 Phono Ph Simul. SB
VHS VH MiniDisc VH Computer PC
Choosing source logos
Note at any time in the source configuring process you can use the
handset Mute key to return to the root menu with a display like ‘500’ or
‘200’.
In Config mode:
1. Press Source until you see a Remote-key (source) + logo display like
2. Press Source until the Remote key name for the source you wish to
configure is displayed.
3. Use the
and Volume keys until the correct logo is indicated – see
the list above.
4. Make changes for all the source options.
CD CD