Filter
Top Products
Customising 562 using Config 19
562 User Guide
This means the product address is 1. The Meridian 500 comms system
allows for up to eight products of the same type operating on the network.
Unless you are setting up a Multiroom system, or are advised to do so by
Meridian support personnel, we suggest you leave this on address 1.
Note This setting has no meaning in 200 comms mode
Note When customisation is complete, switch the power off and then on
again to restore Normal mode and to save what you have done.
Setting the DAC mode for 562
In Config mode:
1. Press Copy until you see a display like:
This means there is no internal DAC (digital–to–analogue converter)
option fitted and that you have not fitted an external DAC.
For guidance on this question see Page ??.
2. Use the
and , Volume keys to choose between:
• DACT, either an external DAC (like the Meridian 203, 263 or 563) is
connected between the second digital output Do2 and the DAC
socket (used as an input), or, an internal DAC option will be
configured in Tape mode. This mode guarantees that any source
can be copied to the analogue tape outputs irrespective of the
listening source or secondary inputs.
• DACV, internal DAC option only. The internal DAC has a variable
output, that appears on the DAC socket. Use this setting if you
want 562 to function as an analogue-output preamplifier with
volume control from the remote control and front panel.
• DACF, internal DAC option only. The internal DAC has its output
fixed at 2V and the output that appears on the DAC socket. Use
this setting if you want a fixed-level analogue copy of the main
digital output.
• DACH, internal DAC option only. The internal DAC has a variable
output, that appears on the DAC socket. In this case the output
level is controlled only by the volume keys on the front panel of
562, and this setting is ignored by the rest of the installation. Use
this setting to drive headphones from the DAC output.
For guidance on this question see Page ??.
Setting the Volume mode for 562
In Config mode:
1. Press Copy until you see a display like:
In the 500 comms system there is provision for two volume controls, main
and secondary.
NDAC
VolM