Filter
Top Products
21
How to Operate the C2200, con’t
Figure 32
Figure 33
Default Settings
To restore the C2200 to Factory Default Settings perform
the following. Press and hold in the MONO Push-button
together with the OUTPUTS 2 Push-button. Approximately
5 seconds after holding in the two the Front Panel Push-but-
tons together, the Front Panel Alphanumeric Display will
indicate MASTER RESET. Refer to figure 32.
Release both Push-buttons and the Front Panel Alphanu-
meric Display will now indicate -- CLEARED - - and the
C2200 will switch Off. Refer to figure 33.
Press the STANDBY/ON Push-button on the C2200 and
proceed to the Setup on page 14 to re-enter and custom set-
ting that have beeen previously made.
Output Meters
The C2200’s Output Meters indicate the Output Voltage
available at the MAIN and OUTPUT 1 & 2 Jacks to drive
Power Amplifiers. Refer to figure 34. The Meters are cali-
brated in dBs (decibles) and respond to all the peaks con-
tained in the musical information. They indicate to an accu-
racy of at least 95% of a single cycle from a 2000Hz tone
burst.
The Meter Electronic Circuitry “Time Stretches” the
Meter Drive Signal so the Meter Pointer pauses just long
enough for the human eye to see it and is followed by a
moderate decay rate.
Figure 34