Filter
Top Products
17
Setup, con’t
Pass Thru Mode
The C2200 can be part of a Multichannel Sound System.
The Right and Left Front Channels from a McIntosh Pro-
cessor or Decoder can “Pass Thru” the C2200 and on to its
associated Power Amplifier(s). The Setup Mode allows the
Selection of the Input that will be used for the Right and
Left Front Channels Pass Thru Mode. In the example be-
low, the Right and Left Front Channels from the Multichan-
nel Processor/Decoder will be connected to the AUX Input
on the C2200.
Note: The C2200 has the ability to switch Off the Meter
Illumination when it is in the Pass Thru Mode. This is
accomplished by switching Off the Meter Illumination
before entering the Setup Mode.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the BALANCE Control Knob until the words
PASSTHRU OFF appears. Refer to figure 17.
3. Rotate the INPUT Control until the Front Panel Alpha-
numeric Display indicates PASSTHRU AUX. Refer to
figure 18.
4. Press the SETUP Push-button to exit the Setup Mode.
Figure 17
Figure 18
Power On Option
Remote Control Selection
There are two choices for the Remote Control Codes the
C2200 will respond to. The Remote Control included with
the C2200 utilizes the NORMal McIntosh Control Codes.
The Second Set of Control Codes the C2200 will respond to
is referred to as the ALTernate Codes. The ALTernate Codes
are for when the C2200 is used together with a McIntosh
Multichannel Processor/Decoder in the Pass Thru Mode
Hookup. This will prevent the Remote Control from affect-
ing the operation of both units at the same time.
Note: If the ALT Remote Control Code is selected, the C2200
will not respond using the supplied McIntosh Remote
Control.
1. Press the SETUP Push-button to access the Setup
Mode.
2. The Front Panel Alphanumeric Display will change and
the Red LED above the SETUP Push-button will be il-
luminated.
3. Rotate the Front Panel METER LIGHTS (Menu) Con-
trol until the words REMOTE NORM appears. Refer
to figure 21.
4. Rotate the Front Panel BALANCE (Select) Control un-
til the Front Panel Alphanumeric Display indicates RE-
MOTE ALT. Refer to figure 22.
5. Press the SETUP Push-button to exit the Setup Mode.
The Power On Option Feature permits using the Main
POWER Switch instead of the STANDBY/ON Push-button
for switching the C2200 Preamplifier On or Off.
Note: If the Power On Option is switched to the AUTO Mode
and the Main POWER Switch is in the Off position, the
Front Panel STANDBY/ON Push-button and the
Remote Control POWER Push-button will be unable to
switch Power On to the C2200.
1. Press the SETUP Push-button to access the Setup
Mode.
2. The Red LED above the SETUP Push-button will illu-
minate.
Figure 20
Figure 19
3. Rotate the Front Panel METER LIGHTS (Menu) Con-
trol until the Front Panel Alphanumeric Display indi-
cates POWERON STBY. Refer to figure 19.
4. Rotate the BALANCE (Select) Control until the Front
Panel Alphanumeric Display indicates POWERON
AUTO. Refer to figure 20.
Figure 21
Figure 22