Filter
Top Products
4-7
Nº 320S Controls & Modes
8. When the desired adjustments have been made, press and
release the balance button to close the balance control.
• Otherwise, the balance control automatically closes a few
seconds after the last command is received. If this occurs,
the selected setting is automatically applied.
9. Press and release the mono button to cancel L + R mono
playback and return to stereo playback.
L – R Phono Alignment L – R mono playback simplifies the process of aligning phono
Tip cartridge azimuth.
To use L – R mono playback to align phono cartridge azimuth:
1. Press and hold the remote control mono button until the
MODE parameter opens on the front panel display as shown
to the left.
2. Press and release the mono button to cycle through all
available MODE parameter settings until the L – R mono
mode is selected as shown to the left.
3. Press and release the front panel or remote control enter
button to close the MODE parameter.
• Otherwise, the MODE parameter automatically closes a
few seconds after the last command is received. If this
occurs, the selected setting remains selected.
4. When the MODE parameter is closed, press and release the
remote control mono button to activate L – R mono playback.
5. Begin playback of the desired mono recording.
6. Using the L – R output signal, adjust the associated phono
cartridge azimuth to achieve minimal output signal.
• Playing a mono recording when L – R mono playback is
activated should result in silence (no output signal).
Because phono cartridges differ, it is recommended to
adjust azimuth to achieve minimal output signal.
7. Press and release the mono button to cancel L – R mono
playback and return to stereo playback.
MODE: L + R
MODE: L – R