Filter
Top Products
1-8
Getting Started Mark Levinson
Warm-Up & Break-In Period (continued)
After this initial period, performance will remain consistent unless
power is disconnected from the ~ac mains connector. Power is
disconnected from the ~ac mains connector when the Nº 320S is
powered off with the front panel power button; the power cord is
disconnected from the ~ac mains connector or the electrical outlet;
or an extended power failure or power outage occurs. Power is not
disconnected from the ~ac mains connector when the Nº 320S is
in standby.
When power returns, the Nº 320S will require a brief warm-up
and break-in period (not the full 300 hours). It is recommended to
allow the Nº 320S and other audio components to stabilize for
about 2 minutes.
Note
• When powered on with the front panel power button,
the Nº 320S automatically enters standby after completing
the initialization sequence.
• The main output connectors are muted while the Nº
320S performs the initialization sequence.
Continuous Operation The Nº 320S should be unplugged during lightning storms and
extended periods of non-use. Otherwise, it is designed for
continuous operation. For best performance, make sure power is
connected to the ~ac mains connector at all times. During
normal operation, do not use the power button to power off the
Nº 320S. Instead, use the front panel or remote control standby
button to place the Nº 320S into standby, which allows the Nº
320S to remain warmed-up to deliver optimal performance at all
times.
Quick Start Guide
These instructions are intended to accommodate immediate use of
the Nº 320S. However, it is important to read this owner’s manual
before attempting more extensive use. This owner’s manual contains
information about features that enhance operation and performance,
as well as important safety, installation, and operation instructions
designed to prevent personal injuries as well as product damage.