Filter
Top Products
4-1
Standby
Allows the Nº 320S to remain warmed-up to deliver optimal
performance at all times. The Nº 320S cannot be placed into
standby unless it is powered on with the front panel power
button. Refer to Continuous Operation (page 1-8) for additional
information.
To place the Nº 320S into or take the Nº 320S out of standby:
1. Make sure the Nº 320S is powered on with the front panel
power button.
2. Press and release the front panel or remote control standby
button.
• When the Nº 320S is not in standby, pressing and releasing
the standby button places the Nº 320S into standby. The
front panel standby LED blinks red to indicate that the
Nº 320S is in standby.
• When the Nº 320S is in standby, pressing and releasing
the standby button takes the Nº 320S out of standby. The
front panel standby LED lights red to indicate that the
Nº 320S is not in standby.
Note
When powered on with the front panel power button, the
Nº 320S automatically enters standby after completing the
initialization sequence.
SLEEP Controls the sleep timer, which configures the Nº 320S to
-OFF-, 0h 30m to 4h 0m automatically enter standby after a designated amount of time has
passed. The SLEEP parameter can be set to –OFF– or in 30-minute
increments between 30 minutes and 4 hours. The factory-default
SLEEP parameter setting is –OFF–.
(continued)
Controls & Modes
4