Filter
Top Products
75
Basic versionSimple version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Advanced version
Using macro operations
[Example] Using the recorded macro operations to button “1”
1
Press the MACRO.
“MACRO” is shown in the MACRO
indicator and remote control display.
2
Press the number button (“1”)
that you want to use.
Macro operations recorded to number
button “1” are performed one at a time.
• The step number shown in the remote
control display disappears after the step is
performed.
• When all macro operations are completed,
the remote control returns to the amp
operation mode.
Deleting recorded macro operations
[Example] Deleting the macro operations recorded to button“2”
1
Press and hold MACRO and
MENU together until “MACRO”
ashes in the LEARN indicator,
MACRO indicator and remote
control display.
2
Press and hold CLR and the
number (“2”) that you want
to delete for approximately 3
seconds.
“M2-CL” flashes in the remote control
display.
3
Press the ENTER.
The recorded macro operation is deleted,
and the remote control returns to step 1.
• To cancel the macro delete operation, press
a different button without pressing
ENTER.
4
When the macro operation delete is complete,
press and hold ENTER until the MACRO indicator
switches off.
Adjusting the interval time of macro operations
transmitting
The macro operation transmission interval can be adjusted.
• The factory setting is “1 second”.
1
Press and hold MACRO and
SOURCE SEL until “SETUP”
is shown in the remote control
display.
“SETUP” is shown for 3 seconds in
the remote control display, after which
“MCR05z” is displayed.
z The current transmission interval is
shown.
2
Press o p to change to the desired transmission
interval.
• The interval time can be changed from 0.5 to 5 seconds by 0.5
seconds step.
3
When the adjustment is complete, press and hold
ENTER until the MACRO indicator switches off.
Operating macro function
Setting the back light
Press the Light button on the side of the remote control, and the
buttons on the remote control light for 2 seconds. If the Light button
is pressed while the buttons are lit, the buttons remain lit for another
2 seconds.
• Backlight is set on in the factory settings.
n Disabling the backlight
Press and hold both SET and
STANDBY until indicator ashes
twice.
n Turning the backlight on
Press and hold both SET and ON
until indicator ashes twice.