Marantz SR6005 Home Theater System User Manual


 
68
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Information
Show information about receiver settings, input signals, etc.
Items Setting details
Status
Show information about
current settings.
n MAIN ZONE
This item shows information about settings for MAIN ZONE.
The information displayed differs according to the input source.
Select Source / Name / Surround Mode / Input Mode /
Decode Mode / HDMI / Digital / Component / Video Select /
Video Mode / Content Type / Video Convert / i/p Scaler /
Resolution / Progressive Mode / Aspect etc.
n ZONE2
This item shows information about settings for ZONE2.
Power / Select Source / Volume Level
Audio Input Signal
Show information about
audio input signals.
Surround Mode : The currently set surround mode.
Signal : The input signal type.
fs : The input signal’s sampling frequency.
Format : The number of channels in the input signal (front, surround, LFE).
Offset : The dialogue normalization correction value.
Flag : This is displayed when inputting signals including a surround back
channel. “MATRIX” is displayed with Dolby Digital EX and DTS-ES Matrix
signals, “DISCRETE” with DTS-ES Discrete signals.
Dialogue normalization function
This function is automatically activated when playing Dolby Digital
sources.
It automatically corrects the standard signal level for individual program
sources.
The correction value can be checked using the
STATUS.
The figure is the corrected value.
This cannot be changed.
HDMI Information
Show information about
HDMI input/output signals
and monitor.
HDMI Signal Information
Resolution / Color Space / Pixel Depth
HDMI Monitor Information
Interface / Supported resol.
Preset Channel
Show information about
preset channels.
SIRIUS
HD Radio
A / B / C / D / E / F / G
A1 – A8 / B1 – B8 / C1 – C8 / D1 – D8 / E1 – E8 / F1 – F8 / G1 – G8
Other settings
Remote control settings
• When you connect a remote control receiver unit (purchased separately) to the REMOTE CONTROL IN
terminal of this unit, use the following procedure to disable the remote sensor function of this unit.
• The remote sensor function of remote control signals is enabled by default.
MENU
ON/STANDBY
o
n Disabling the sensor function of the remote control unit
When the main unit is in standby mode, press ON/STANDBY while holding down o and
MENU on the main unit.
“Remote Lock:ON” is shown on the display, and the infrared light receiving function is disabled.
n Enabling the remote sensor function
When the main unit is in standby mode, press ON/STANDBY while holding down o and
MENU on the main unit.
The infrared light receiving function on the main unit is enabled.
NOTE
If a remote control receiver unit (purchased separately) is not connected, do not perform this setting. If you
do, you will not be able to operate this unit using the remote control unit.