Filter
Top Products
12
ENGLISH
6. Select a function (Play mode)
1 Turn the JOG control m to select the source (TUNER or
CD) to be played.
2 Press the TIMER button ⁄0.
3 When you select “TUNER”, turn the JOG control m to
select a preset number to be received.
When you select “CD”, turn the JOG control m to select
a track number to be played.
4 Press the TIMER button ⁄0.
Note:
If you select a track number which is not on the CD, the play
mode will start track number 1 when the timer activates.
7. Adjust the volume level
1 Turn the JOG control m to adjust the volume level.
2 Press the TIMER button ⁄0.
8. Set Once or Daily
1 Turn the JOG control m to select the “Once”, when you
use this programmed event only once.
Turn the JOG control m to select the “EveryDay”, when
you use this programmed event everyday.
2 Press the TIMER button ⁄0.
Note:
If you select the “TimerOff”, this setting is cancelled.
In recording mode, the power is turned on before 1
minute at timer setting time.
9. Press the TIMER button ⁄0 to decide the setting.
“TIMER” lights up in red. The setting contents are scrolled.
10. Press the power switch z to set the timer standby mode.
This system (SR110 and the connected components) is set
standby mode and the displays are turned off. The power
switch of SR110 lights up in amber.
Note:
Timer will not be activate when the power is turned on. Set
the standby mode to activate the timer.
You can set the timer standby mode by pressing the power
switch z while scrolling the setting contents.
PROGRAMME TIMER SETTING WITH REMOTE
CONTROL
You can set the timer setting with the power, 4, ¢ and
TIMER buttons on the remote control.
Press the 4 or ¢ button o !0 instead of turning the JOG
control m.
Other procedures are same as “Programme Timer Setting”
with SR110.
Important
- Timer play mode cannot activate when no disc is inserted
in the selected source.
NOTE OF THE TIMER FUNCTIONS
• If the displayed time blinks, the time is incorrect. You need
to set the correct time.
• SR110 can save the present time for 5 minutes if the AC
plug is pulled out the AC outlet. If the AC plug is plugged
into the AC outlet within this period (5 minutes), the present
time data is hold. You do not need to set the present time
again.
CONFIRM AND CHANGE TIMER SETTING
1. Press the power switch q/z to turn the power of the unit
ON.
2. Display the contents of timer setting by pressing the TIMER
button !8/⁄0.
The following programmed contents are displayed by
pressing the TIMER button !8/⁄0.
3. You can change the displayed content with the JOG
control m if necessary.
4. Press the power switch q/z again.
Important
- Timer mode is cancelled if you quit confirming halfway
through a procedure.
- Never confirm the setting after play mode starts, this will
lead to the off timer setting is cancelled and the power is
not turned off.
TIMER TIMER
TIMER
TIMER