Filter
Top Products
9
ENGLISH
TUNER OPERATION
TO LISTEN TO THE TUNER
1. Press the power switch q/z to turn the power ON.
2. Press the TUNER button . or FM/AM button w.
“TUNER” is displayed.
3. To select the band of reception, press the BAND button ⁄1
or the FM/AM w button on the remote control.
4. Press the TUNER button . to set the frequency.
“FREQ” is displayed.
5. Turn the JOG control m clockwise to increase or counter-
clockwise to decrease the frequency, or press ¡ button
!2 to increase or 1 button !3 to decrease.
Auto scan tuning
To start the auto scan tuning, turn the JOG control m or press
and hold 1/¡ button !2/ !3 for a while continuously. Auto
scan tuning stops automatically when a broadcasting station
is tuned in, and the “TUNED” display lights up. When SR110
receives stereo broadcasting, “STEREO” display also lights
up.
6. Adjust the volume with the VOLUME control ⁄4 or VOLUME
buttons yu.
To receive sound in monaural, press the TUNER button .
until “TUNERMOD” is displayed. Turn the JOG control m
to display “MONO”.
Note:
- “AUTO” is set at initial. In this case, the noise is muted
when SR110 tunes a frequency of FM band which has no
broadcasting.
- Muting of the FM band is not activated when the tuner
mode is set to MONO. Please take care with the volume.
PRESET MEMORY OPERATION
The SR110 receiver can store up to 30 stations selected in the
FM and AM bands.
The preset memory function allows frequency, receiving mode
(STEREO or MONO) and also station name to be stored in the
memory. The preset memory can be stored in two ways:
Manual preset memory
1. Select the desired station, referring to “TUNER
OPERATION”.
2. Press the MEMO button ⁄2.
The “M” indicator will blink for approx. 5 seconds.
During this period.
3. Select the preset number by turning the JOG control m
right for up or left for down
4. Press the JOG control m to decide.
The preset number can be selected by directly entering it
with the numeric buttons on the remote control.
Auto preset memory
This allows a band to be scanned automatically, a station with
good reception to be found and to be stored in the preset
memory.
1. Press the TUNER button . or FM/AM button w.
“TUNER” is displayed.
2. Press and hold down the MEMO button ⁄2 for 3 seconds or
more.
The auto preset memory operation starts.
“AutoMemo” is blinking.
3. When a station is received, scanning pauses for 5
seconds.
4. Press the JOG control m to store the received station
within 5 seconds. The scanning restarts after pressing the
JOG control m.
If the JOG control m is turned within 5 seconds, scanning
restarts and the frequency being received is not stored in
the memory.
R
TM
+
PHONES
WOW
MEMO
BAND
TIMER
TUNER
AMP
VOLUME
STANDBY DISPLAY MUTE OPEN
15
2, 4
36
TUNER TUNER
BAND
TUNER
R
TM
+
PHONES
WOW
MEMO
BAND
TIMER
TUNER
AMP
VOLUME
STANDBY DISPLAY MUTE OPEN
3, 4
2
R
TM
+
PHONES
WOW
MEMO
BAND
TIMER
TUNER
AMP
VOLUME
STANDBY DISPLAY MUTE OPEN
41 2
TUNER MEMO