Filter
Top Products
4
ENGLISH
CONNECTORS AND CONTROLS
ON THE MAIN UNIT
A Terminal for FM antenna, 75 ohms
For connecting an external FM antenna with a circular plug, or for
connecting a cable network.
Terminals for AM antenna and
Grounding
To connect the supplied AM loop antenna, use the terminals
marked “AM” and “GND”.
In areas where the AM loop antenna gives unsatisfactory results,
it is recommended that the receiver be connected to an outdoor
antenna. Use the terminal marked ‘AM’ for this. A grounding lead
can be connected to the terminal marked ‘GND’ to further reduce
interference. In this case, it must be connected together with the
supplied loop antenna.
B CD input jacks
Connect to the audio output jacks of a CD player.
C AUX input jacks
Connect to the audio output jacks of the TV set, DVD player, etc.
D CD-R input/output jacks
Connect the IN jacks to the output jacks of a CD-R player, and
the OUT jacks to its input jacks.
E MD input/output jacks
Connect the IN jacks to the output jacks of a MD player, and the
OUT jacks to its input jacks.
F REMOTE CONTROL jacks
Connect to a component equipped with remote control jacks.
(Refer to page 3.)
G System control switch
This switch selects the system operation mode. Set to SYSTEM
position when the unit is being used in combination with a CD
(CD110). If your component is not capable of system connection,
set this switch to INT position.
H AC power cord
Plug into an AC 120V household outlet.
I SPEAKER terminals
Connect the left and right speaker leads, observing the + and –
polarity of the leads and terminals.
z STANDBY/power switch and
indicator
Press to turn power ON and press again to switch to STANDBY
mode. The indicator lights GREEN when power is ON, and lights
RED when in STANDBY mode. The indicator lights AMBER when
the timer program is set during STANDBY mode.
x DISPLAY button
This button is used to change the display for information such as
clock time.
A present time can be displayed for 10 seconds in standby mode
by pressing this button.
The brightness of the display can be changed to dimmer or normal
by pressing this button.
c MUTE button
This button is used to mute the sound from the speakers. When
this button is pressed, the speakers’ sound level is muted and
“MUTE” appears on the display. Pressing this button again cancels
the muting function, and it can also be cancelled by pressing one
of the function buttons.
v Door OPEN button
This button is used to open the door.
b Front panel door
This door be opened by pressing the door OPEN button.
n IR lens
You can operate the unit even if the receiver door is closed. The
infrared signal from the remote control enters the unit through
this lens and infrared sensor.
Note:
Never remove this lens. If you remove this lens, the receiver
cannot receive the infrared signal from remote control when
the SR110’s door is closed.
m JOG control
The JOG control can be used in the AMP, TUNER and TIMER
modes. Details of operation are as follows:
AMP mode: Source select (Usual setting)
Balance control (AMP button is pressed twice)
Treble control (AMP button is pressed three
times)
Bass control (AMP button is pressed four times)
(When the AMP button is pressed once, volume
control mode is set for volume control knob.)
TUNER mode: Frequency scan mode (last operation is
memorised)
Preset memory mode (last operation is
memorised)
Auto, Mono selecting Mode
TIMER mode: Program and confirm timer setting
For more detail, refer to the respective page.