Filter
Top Products
6
ENGLISH
CONNECTIONS
SYSTEM CONNECTION
FEATURES OF SYSTEM CONNECTION
Synchronized power ON/OFF
By switching the power switch q/z, you can turn the CD
player, CD Recorder and MD deck connected through the
REMOTE CONTROL bus connection ON or OFF.
You cannot turn on and off by pressing the power switch of
connected components.
Auto source selection
When the CD in the CD110 starts playing by pressing the
play button on the CD110, the SR110 receiver will change
source automatically.
CONNECT TO SYSTEM CONNECTION
This unit is equipped with the remote control bus function.
Connecting it to Marantz AV system components equipped with
REMOTE CONTROL jacks, such as a CD player (CD110),
means that these components can be remote controlled from
this unit (SR110).
Connect the REMOTE CONTROL jacks of this unit to the
REMOTE CONTROL jacks of another component using RCA-
type pin lead provided.
To operate the SR110 in the SYSTEM mode, the leads from the
other components must be connected to the SR110.
The lead from OUTPUT terminal of other component is
connected to INPUT terminal of the SR110.
Set the REMOTE CONTROL selector of this unit (SR110) to
SYSTEM position. Set the REMOTE CONTROL selector of
connected components to EXT position.
Note:
– Plug into AC outlet after all connections are finished.
– When connecting the supplied audio cable, confirm the
red plugs are connected to R jacks and the white plugs
are connected to L jacks.
We recommend you use to supplied audio cable.
– When using the supplied digital optical cable, remove the
dust cover.
– Attach the dust cover to prevent dust when removing the
digital optical cable.
– When connecting the digital optical cable, make sure it is
fully inserted.
IMPORTANT
– When the system connection is setup, SR110 and CD110
should be stacked as following figures.
SYSTEM OPERATION
The remote control system can be used to control Marantz
system components equipped with REMOTE CONTROL (Bus)
jacks and SYSTEM (Bus) jacks, such as CD110. An example
procedure for system operation is described below. Here, we
take as an example the connection of a CD player (CD110) to
this receiver (SR110) through the REMOTE CONTROL jacks.
(The numbers of controls and buttons on the main unit are
enclosed in , and those on the remote control are enclosed in
.)
1. Press the power switch q/z to turn the receiver power
ON.
2. All the components connected to the REMOTE CONTROL
jacks are turned ON.
3. Press the CD button w to select CD player as a source
and set the remote control to CD mode.
4. Press the “5” of the numeric button e to select track
number 5 of the CD.
5. The CD player (CD110) starts to play the CD.
6. Press the VOLUME buttons yu or turn the VOLUME
control ⁄4 to adjust the listening volume.
7. Press the 7 !1 button to stop the CD.
8. Press the power switch q/z to turn the power off and into
the standby mode.
The SR110 receiver and all the components connected to it
are turned OFF.
NO SYSTEM CONNECTION
You can use connected components as a single unit by setting
the system control switch to INT position.
When you use this unit in combination with other Marantz
components for which a system connections is not possible, or
components of other brands, you can use them independently
by setting the system control switch to INT position.
NOTE OF SPEAKER CABLE
When connecting the speaker cable, you use the cable as
following figures;
Never use the cable as following figures. If you use the
following cable, the speaker terminal may be damaged.
0.6 mm -1.5 mm
x mm >1.5 mm
SR110
STANDBYDISPLAY MUTEOPEN
CD110
STANDBY OPEN
SR110
CD110