Filter
Top Products
52 Issue 1 CRCS R6.0 April 1999
Appendix A: Modem Pooling
If you begin with the Async_Dial Factory default option settings, then the AT com-
mands and Diagnostic Control Panel LCD command sequences to option the
options are as shown in the following list:
Clear options/registers to factory default: &F0 (Configure/Factory)
DTR call control is enabled: &D2 (Configure/Edit/DTE Interface)
DSR tracks data set ready: &S1 (Configure/Edit/DTE Interface)
Numeric form (2) of result codes is enabled: V2 (Configure/Edit/DTE
Dialer)
Extended Result Codes set to Use_DTE_Rate: X7 (Configure/Edit/DTE
Dialer)
Long space disconnect is disabled: Y0 (Configure/Edit/Line Dialer)
MNP5 Compress is disabled: %C0 (Configure/Edit/V42/MNP/Buffer)
Dial Line Rate is set to 9600 bps: S41=3 (Configure/Edit/Dial Line)
Disable the AT Escape Char option: S2=128 (Configure/Edit/DTE Dialer)
Command echo is disabled: E0 (Configure/Edit/DTE Dialer)
Store option/register changes to Active(Save): &W0 (Configure/Save)
Test DTE RL (CT140) Disable S51=0
DTE LL (CT141) Disable S52=0
Test Timeout Disable S18=0
Rcv Remote Loop Enable AT&T..
V54 Address Disable S53=0
V54 Device Type Peripheral S54=0
Misc StrapsWhenDisc No_Change S88=0
Speaker Control OnUntilCarr ATM..
Speaker Volume Medium ATL..
Access frm Remt Enable S55=0
Dir#1_Callback Disable S67=0
Table 3. 3800 Series Modem Installation — Continued
Activ (Operating) Option Selection AT Command